Mitigation of Gear Mesh-Frequency Noise Using a Hydrostatic Bearing
- 1 June 2015
- journal article
- Published by ASME International in Journal of Vibration and Acoustics
- Vol. 137 (3) , 034502
Abstract
A proposed solution to reducing gear mesh-frequency vibrations in a gear-set involves the utilization of hydrostatic bearings placed in series, load wise, with the main support bearing. The hydrostatic bearings are expected to utilize its low pass filtering effect of the vibrational energies to prevent its transmission from the shaft to the gear housing where it would be emitted as noise. The present investigation examines the frequency response of a single-recess circular hydrostatic bearing under applied sinusoidal loads. The results show that as the driving frequency increases, the filtering effect of the hydrostatic bearing increases. The exhibited behavior is similar to the behavior of a low pass filter: negligible filtering effect at low frequencies, the filtering effect increasing from 0% to 90% over the midfrequencies range and the filtering effect remaining at the maximum value as the frequencies of the applied signals continue to increase. This observed behavior is expected to play a central role in the proposed gear mesh-frequency vibration mitigation system.Keywords
This publication has 6 references indexed in Scilit:
- Gear Noise and Vibration Prediction and Control Methods2007
- Equivalent Stiffness and Damping Investigation of a Hydrostatic Journal BearingTribology Transactions, 2007
- Effects of fluid compressibility on the dynamic response of hydrostatic journal bearingsWear, 1991
- Compressibility and inertia effects on the dynamic behaviour of recessed hydrostatic bearingsTribology International, 1989
- Rotordynamic coefficients of multirecess hybrid journal bearings part IWear, 1989
- Recess Volume Fluid Compressibility Effect on the Dynamic Characteristics of Multirecess Hydrostatic Journal Bearings With Journal RotationJournal of Tribology, 1987