Modelling the effect of roughness density on turbulent forced convection
Authors:
Open Access
- 11 January 2024
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 979
Abstract
By examining a systematic set of direct numerical simulations, we develop a model which captures the effect of roughness density on global and local heat transfer in forced convection. The surfaces considered are zero-skewed three-dimensional sinusoidal rough walls with solidities, $\varLambda$ (defined as the frontal area divided by the total plan area), ranging from low $\varLambda = 0.09$ , medium $\varLambda = 0.18$ to high $\varLambda = 0.36$ . For each solidity, we vary the roughness height characterised by the roughness Reynolds number, $k^+$ , from transitionally rough to fully rough conditions. The findings indicate that, as the fully rough regime is approached, there is a pronounced breakdown in the analogy between heat and momentum transfer, whereby the velocity roughness function $\Delta U^+$ continues to increase and the temperature roughness function $\Delta \varTheta ^+$ attains a peak with increasing $k^+$ . This breakdown occurs at higher sand-grain roughness Reynolds numbers ( $k_s^+$ ) with increasing solidity. Locally, we find that the heat transfer can be meaningfully partitioned into two categories: exposed, high-shear regions experiencing higher heat transfer obeying a local Reynolds analogy and sheltered, reversed-flow regions experiencing lower and spatially uniform heat transfer. The relative contribution of these distinct mechanisms to the global heat transfer depends on the fraction of the total surface area covered by these regions, which ultimately depends on $\varLambda$ . These insights enable us to develop a model for the rough-wall heat-transfer coefficient, ${C_{h,k}(k^+, \varLambda, Pr)}$ , where $Pr$ is the molecular Prandtl number, that assumes different heat-transfer laws in exposed and sheltered regions. We show that the exposed–sheltered surface-area fractions can be modelled through simple ray tracing that is solely dependent on the surface topography and a prescribed sheltering angle. Model predictions compare well when applied to heat-transfer data of traverse ribs from the literature.
Keywords
Funding Information
- Australian Research Council (DP200100969)
- Australian Research Council (LP180100712)
This publication has 85 references indexed in Scilit:
- Numerical simulation of wall roughness on gaseous flow and heat transfer in a microchannelInternational Journal of Heat and Mass Transfer, 2006
- Local heat transfer around a wall-mounted cube in the turbulent boundary layerInternational Journal of Heat and Mass Transfer, 2001
- Improved Aerodynamic Characterization of Regular Three-Dimensional RoughnessAIAA Journal, 1998
- Direct Numerical Simulation of Passive Scalar Field in a Turbulent Channel FlowJournal of Heat Transfer, 1992
- Rough-Wall Turbulent Boundary LayersApplied Mechanics Reviews, 1991
- Temperature and concentration profiles in fully turbulent boundary layersInternational Journal of Heat and Mass Transfer, 1981
- A generalized correlation of roughness density effects on the turbulent boundary layer.AIAA Journal, 1973
- Heat transfer and friction in tubes with repeated-rib roughnessInternational Journal of Heat and Mass Transfer, 1971
- Heat-transfer and friction properties of surfaces with discrete roughnessesInternational Journal of Heat and Mass Transfer, 1966
- Heat and momentum transfer in smooth and rough tubes at various prandtl numbersInternational Journal of Heat and Mass Transfer, 1963