Fuel Economy and CO 2 Emissions of Ethanol-Gasoline Blends in a Turbocharged DI Engine
Authors:
- 8 April 2013
- journal article
- Published by SAE International in SAE International Journal of Engines
- Vol. 06 (1) , 422-434
Abstract
Engine dynamometer testing was performed comparing E10, E20, and E30 splash-blended fuels in a Ford 3.5L EcoBoost direct injection (DI) turbocharged engine. The engine was tested with compression ratios (CRs) of 10.0:1 (current production) and 11.9:1. In this engine, E20 (96 RON) fuel at 11.9:1 CR gave very similar knock performance to E10 (91 RON) fuel at 10:1 CR. Similarly, E30 (101 RON) fuel at 11.9:1 CR resulted in knock-limited performance equivalent to E20 at 10:1 CR, indicating that E30 could have been run at even higher CR with acceptable knock behavior.The data was used in a vehicle simulation of a 3.5L EcoBoost pickup truck, which showed that the E20 (96 RON) fuel at 11.9:1 CR offers 5% improvement in U.S. EPA Metro-Highway (M/H) and US06 Highway cycle tank-to-wheels CO₂ emissions over the E10 fuel, with comparable volumetric fuel economy (miles per gallon) and range before refueling. The results also indicated that the E30 (101 RON) fuel at 11.9:1 CR provides improvements in CO₂ emissions of 5% on the EPA M/H cycle and 7.5% on the US06 Highway cycle, while volumetric fuel economy was 3% lower on the M/H cycle and approximately equal on the US06 Highway cycle, compared to the baseline E10 fuel at 10:1 CR.Keywords
This publication has 14 references indexed in Scilit:
- FMVSS 226 Ejection Mitigation: A ReviewSAE International Journal of Advances and Current Practices in Mobility, 2013
- High octane number ethanol–gasoline blends: Quantifying the potential benefits in the United StatesFuel, 2012
- Effect of Heat of Vaporization, Chemical Octane, and Sensitivity on Knock Limit for Ethanol - Gasoline BlendsSAE International Journal of Fuels and Lubricants, 2012
- Ethanol and its Potential for Downsized Engine Concep tsMTZ Worldwide, 2012
- Implications of the Energy Independence and Security Act of 2007 for the US Light-Duty Vehicle FleetSAE International Journal of Advances and Current Practices in Mobility, 2009
- Effects of Combustion Phasing, Relative Air-fuel Ratio, Compression Ratio, and Load on SI Engine EfficiencySAE International Journal of Advances and Current Practices in Mobility, 2006
- Spark–Ignition Engine Fuel Consumption ModelingSAE International Journal of Advances and Current Practices in Mobility, 1999
- A Method of Predicting Brake Specific Fuel Consumption MapsSAE International Journal of Advances and Current Practices in Mobility, 1999
- Fuel efficiency and the physics of automobilesContemporary Physics, 1997
- a new look at High Compression EnginesSAE International Journal of Advances and Current Practices in Mobility, 1959