Nanosized κ-Carbide and B2 Boosting Strength Without Sacrificing Ductility in a Low-Density Fe-32Mn-11Al Steel
Open Access
- 30 December 2024
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 15 (1) , 48
Abstract
High-performance lightweight materials are urgently needed because of energy savings and emission reduction. Here, we design a new steel with a low density of 6.41 g/cm3, which is a 20% weight reduction compared to the conventional steel. The mechanical properties and microstructures of the steels prepared with different routes are systematically explored by utilizing uniaxial tensile testing and transmission electron microscopy. The steel processed by cold rolling and recrystallization annealing at 950 °C for 15 min shows an ultra-high yield strength of 1241 ± 10 MPa, while retaining a good ductility of 38 ± 1%. The high yield strength is mainly related to the synergistic precipitation strengthening introduced by nanoscale B2 and κ′-carbides. It is encouraging to notice that the yield strength increased without scarifying ductility, compared to the ST steel. The key reason is that the high strain hardening rate is activated by combined factors, including the blockage of numerous twins and nanoscale B2 to the dislocation movements, and dynamic slip band refinement. This study is instructive for concurrently enhancing the strength and ductility of austenitic lightweight steels with fully recrystallized grains and dual nano-precipitates.Keywords
Funding Information
- National Safety Academic Fund (U2330110)
This publication has 68 references indexed in Scilit:
- Role of Nb Addition on Microstructural Stability and Deformation Behaviors of FeMnAlC Lightweight Steels at 400 °CMetallurgical and Materials Transactions A, 2021
- A general perspective of Fe–Mn–Al–C steelsJournal of Materials Science, 2018
- Novel ultra-high-strength Cu-containing medium-Mn duplex lightweight steelsActa Materialia, 2017
- Effect of Ni alloying on the microstructural evolution and mechanical properties of two duplex light-weight steels during different annealing temperatures: Experiment and phase-field simulationActa Materialia, 2017
- Novel ultra-high-strength (ferrite + austenite) duplex lightweight steels achieved by fine dislocation substructures (Taylor lattices), grain refinement, and partial recrystallizationActa Materialia, 2015
- An Atom Probe Study of Kappa Carbide Precipitation and the Effect of Silicon AdditionMetallurgical and Materials Transactions A, 2014
- On the mechanism of twin formation in Fe–Mn–C TWIP steelsActa Materialia, 2010
- Origin of Extended Tensile Ductility of a Fe-28Mn-10Al-1C SteelMetallurgical and Materials Transactions A, 2009
- Effect of alloying additions on the κ phase precipitation in austenitic Fe-Mn-Al-C alloysScripta Metallurgica et Materialia, 1994
- The influence of crystallographic orientation on tensile behaviour in strongly textured Ti6Al4VMaterials Science and Engineering, 1979