Plasticization of Poly‐L‐lactide with L‐lactide, D‐lactide, and D,L‐lactide monomers
- 16 January 2013
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 53 (10) , 2073-2080
Abstract
Poly‐L‐lactide (PLLA) is being widely considered for repair of damaged tissues, for controlled antibiotic release, and also as scaffolds for cultured cells. PLLA was blended with the lactide monomer in its two enantiomeric forms: D‐lactide (D‐la) and L‐lactide (L‐la) and with the cyclic dimmer D,L‐la, in order to enhance its flexibility and thereby overcome its inherent problem of brittleness. In this work, the crystallization, phase structure, and tensile properties of PLLA and PLLA plasticized with 5, 10, 15, and 20 wt% of D‐la, L‐la, and D,L‐la are explored. The three plasticizers used were effective in lowering the glass transition temperature (Tg) and the melting temperature (Tm) of PLLA, around 20°C for a plasticizer content of 20 wt%. The tensile strength and modulus of the blends decreased following the increasing content of plasticizers from approximately 58 MPa to values below 20 MPa, and from 1667 to 200 MPa, respectively. Aging the blends at storage ambient temperature revealed that the enhanced flexibility as well as the morphological stability was lost over time due to the migration of the plasticizer to the surface, this being less marked in the case of D‐la as a result of interactions between the polymer and its enantiomeric monomer of complementary configuration. POLYM. ENG. SCI., 53:2073–2080, 2013. © 2013 Society of Plastics EngineersKeywords
This publication has 23 references indexed in Scilit:
- Plasticization of poly‐L‐lactide for tissue engineeringJournal of Applied Polymer Science, 2011
- Crystallization behavior and mechanical properties of crosslinked plasticized poly(L‐lactic acid)Journal of Applied Polymer Science, 2008
- Crystallization, morphology, and mechanical behavior of polylactide/poly(ε‐caprolactone) blendsPolymer Engineering & Science, 2006
- Plasticization of Poly(l-lactide) with Poly(propylene glycol)Biomacromolecules, 2006
- Plasticized polylactide/clay nanocomposites. I. The role of filler content and its surface organo‐modification on the physico‐chemical propertiesJournal of Polymer Science Part B: Polymer Physics, 2005
- Preparation and Properties of Plasticized Poly(lactic acid) FilmsBiomacromolecules, 2005
- Plasticization of poly(lactic acid) with oligomeric malonate esteramides: Dynamic mechanical and thermal film propertiesJournal of Applied Polymer Science, 2005
- Thermal properties of di- and triblock copolymers of poly(l-lactide) with poly(oxyethylene) or poly(ε-caprolactone)Polymer, 2003
- Synthesis, Characterization, and Hydrolytic Degradation of PLA/PEO/PLA Triblock Copolymers with Short Poly(l-lactic acid) ChainsMacromolecules, 1996
- Poly(3‐hydroxybutyrate)‐co‐(3‐hydroxyvalerate)/Poly‐L‐lactide blends: Thermal and mechanical propertiesJournal of Applied Polymer Science, 1994