Critical Assessment of Contact Resistance and Mobility in Tin Perovskite Field‐Effect Transistors
Authors:
- Youcheng ZhangYZYoucheng Zhang
- Stefano PecorarioSPStefano Pecorario
- Xian Wei ChuaXCXian Wei Chua
- Xinglong RenXRXinglong Ren
- Rozana MazlumianRMRozana Mazlumian
- Satyaprasad P. SenanayakSSSatyaprasad P. Senanayak
- Krishanu DeyKDKrishanu Dey
- Samuel D. StranksSSSamuel D. Stranks
- Henning SirringhausHSHenning Sirringhaus
Open Access
- 16 July 2025
- journal article
- Published by Wiley in Advanced Electronic Materials
- Vol. 11 (15)
Abstract
Recent reports highlight the potential of tin‐based perovskite semiconductors for high‐performance p‐type field‐effect transistors (FETs) with mobilities exceeding 20 cm2 V⁻¹ s⁻¹. However, these high mobilities—often obtained via two‐probe (2P) methods on devices with small channel length‐to‐width ratios (L/W < 0.5) operating in the saturation regime at high drain‐source currents—raise concerns about overestimation due to contact resistance and non‐ideal FET characteristics. Here, gated four‐point probe (4PP) FET measurements is performed on Hall bar devices (L/W = 5) of Cs0.15FA0.85SnI3, obtaining a consistent mobility of 3.4 cm2 V⁻¹ s⁻¹. VG‐dependent 4PP mobility is accurately extracted using the Hofstein and Heiman's MOSFET model. Upon comparing these with gated 2P measurements of narrow‐channel FETs (L/W = 0.1) on the same chip, the contact resistance (RC) is resolved. The 2P linear mobility is underestimated due to voltage drops across RC, while the 2P saturation mobility is overestimated because of high () near the threshold. Contact resistance effects become more pronounced at lower temperatures. Contact‐corrected 4‐point‐probe (4PP) mobilities are independent of bias conditions and are observed to flatten at temperatures lower than 180 K. Future reports of perovskite FET mobilities should include gated 4PP measurements and use devices with larger L/W ratios to minimize nonidealities arising from contact resistance effects.Keywords
All Related Versions
Funding Information
- European Research Council (101020872)
- Engineering and Physical Sciences Research Council (EP/W017091/1, EP/Z531303/1)
This publication has 39 references indexed in Scilit:
- Organic Surface Doping for High‐Performance Perovskite TransistorsAdvanced Functional Materials, 2024
- Enhancing Stability and Performance in Tin‐Based Perovskite Field‐Effect Transistors Through Hydrogen Bond Suppression of Organic Cation MigrationAdvanced Materials, 2024
- Intrinsic (Trap‐Free) Transistors Based on Epitaxial Single‐Crystal PerovskitesAdvanced Materials, 2022
- Photoluminescence Intensity Enhancement in Tin Halide PerovskitesAdvanced Science, 2022
- Optoelectronic Properties of Low‐Bandgap Halide Perovskites for Solar Cell ApplicationsAdvanced Materials, 2021
- Impact of Tin Fluoride Additive on the Properties of Mixed Tin‐Lead Iodide Perovskite SemiconductorsAdvanced Functional Materials, 2020
- Contact Resistance in Organic Field‐Effect Transistors: Conquering the BarrierAdvanced Functional Materials, 2019
- Electrical Instability Induced by Electron Trapping in Low‐Bandgap Donor–Acceptor Polymer Field‐Effect TransistorsAdvanced Materials, 2015
- Charge Injection in Solution‐Processed Organic Field‐Effect Transistors: Physics, Models and Characterization MethodsAdvanced Materials, 2012
- Charge Trapping at the Dielectric of Organic Transistors Visualized in Real Time and SpaceAdvanced Materials, 2008