Rozana Mazlumian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Rozana Mazlumian has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Artem A. Bakulin
Imperial College London
1 shared publication - Ben P. Carwithen
UNSW Sydney
1 shared publication Cong Zhao
Optoelectronics Group Department of Physics Cavendish Laboratory University of Cambridge Cambridge CB3 0HE UK
1 shared publication- Danila A. Barskiy
Johannes Gutenberg University of Mainz
1 shared publication - Dmitry Budker
Helmholtz Institute Mainz
1 shared publication - Erik Van Dyke
Johannes Gutenberg University Mainz
1 shared publication
Latest Publications
- Open Access
- 16 July 2025
- Published by Wiley in Advanced Electronic Materials
- Vol. 11 (15)
Critical Assessment of Contact Resistance and Mobility in Tin Perovskite Field‐Effect Transistors
Recent reports highlight the potential of tin‐based perovskite semiconductors for high‐performance p‐type field‐effect transistors (FETs) with mobilities exceeding 20 cm2 V⁻¹ s⁻¹. However, these high mobilities—often obtained via two‐probe (2P) methods on devices with small channel length‐to‐width ratios (L/W < 0.5) operating in the saturation regime at high drain‐source currents—raise concerns about overestimation due to contact resistance and non‐ideal FET characteristics. Here, gated four‐point probe (4PP) FET measurements is performed on Hall bar devices (L/W = 5) of Cs0.15FA0.85SnI3, obtaining a consistent mobility of 3.4 cm2 V⁻¹ s⁻¹. VG‐dependent 4PP mobility is accurately extracted using the Hofstein and Heiman's MOSFET model. Upon comparing these with gated 2P measurements of narrow‐channel FETs (L/W = 0.1) on the same chip, the contact resistance (RC) is resolved. The 2P linear mobility is underestimated due to voltage drops across RC, while the 2P saturation mobility is overestimated because of high () near the threshold. Contact resistance effects become more pronounced at lower temperatures. Contact‐corrected 4‐point‐probe (4PP) mobilities are independent of bias conditions and are observed to flatten at temperatures lower than 180 K. Future reports of perovskite FET mobilities should include gated 4PP measurements and use devices with larger L/W ratios to minimize nonidealities arising from contact resistance effects.
- 16 July 2025
- Published by Wiley in Advanced Electronic Materials
- Vol. 11 (15)
Open AccessCritical Assessment of Contact Resistance and Mobility in Tin Perovskite Field‐Effect Transistors
Recent reports highlight the potential of tin‐based perovskite semiconductors for high‐performance p‐type field‐effect transistors (FETs) with mobilities exceeding 20 cm2 V⁻¹ s⁻¹. However, these high mobilities—often obtained via two‐probe (2P) methods on devices with small channel length‐to‐width ratios (L/W < 0.5) operating in the saturation regime at high drain‐source currents—raise concerns about overestimation due to contact resistance and non‐ideal FET characteristics. Here, gated four‐point probe (4PP) FET measurements is performed on Hall bar devices (L/W = 5) of Cs0.15FA0.85SnI3, obtaining a consistent mobility of 3.4 cm2 V⁻¹ s⁻¹. VG‐dependent 4PP mobility is accurately extracted using the Hofstein and Heiman's MOSFET model. Upon comparing these with gated 2P measurements of narrow‐channel FETs (L/W = 0.1) on the same chip, the contact resistance (RC) is resolved. The 2P linear mobility is underestimated due to voltage drops across RC, while the 2P saturation mobility is overestimated because of high () near the threshold. Contact resistance effects become more pronounced at lower temperatures. Contact‐corrected 4‐point‐probe (4PP) mobilities are independent of bias conditions and are observed to flatten at temperatures lower than 180 K. Future reports of perovskite FET mobilities should include gated 4PP measurements and use devices with larger L/W ratios to minimize nonidealities arising from contact resistance effects.
- Open Access
- 12 February 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Benchtop Proton NMR Study of Hyperpolarized Charged and Neutral Ir-IMes Hydride Intermediates in Acetonitrile
In this work, we utilize 1H benchtop nuclear magnetic resonance (NMR) spectrometer (proton frequency 44.7 MHz) for real-time monitoring of spin-transfer catalysis and hydrogen-assisted activation process starting from an iridium-based organometallic complex [Ir(IMes)(COD)Cl] (IMes = 1,3-bis(2,4,6-trimethylphenyl)imidazol-2-ylidene, COD = cyclooctadiene). We identify two distinct activation pathways: first, via the formation of neutral intermediate complex [Ir(IMes)(COD)(H2)Cl], and second, via the formation of charged complexes [Ir{+}(IMes) (COD)(H2)R]Cl{-} with bound ligands R = acetonitrile, ammonia, and benzylamine. These ligands originate from substrate choice in the activation process. We conclude that the pathway direction is dominated by solvent polarity. On the basis of this, we develop a protocol for obtaining stable and long-lasting SABRE (Signal Amplification by Reversible Exchange) polarization of an acetonitrile solvent in the presence of a benzylamine coligand. These results are important for better understanding of the chemical dynamics in SABRE systems as well as for the fundamental physics experiments that require large and long-lasting polarization of highly-concentrated molecules (e.g., those from the solvent itself).
- 12 February 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessBenchtop Proton NMR Study of Hyperpolarized Charged and Neutral Ir-IMes Hydride Intermediates in Acetonitrile
In this work, we utilize 1H benchtop nuclear magnetic resonance (NMR) spectrometer (proton frequency 44.7 MHz) for real-time monitoring of spin-transfer catalysis and hydrogen-assisted activation process starting from an iridium-based organometallic complex [Ir(IMes)(COD)Cl] (IMes = 1,3-bis(2,4,6-trimethylphenyl)imidazol-2-ylidene, COD = cyclooctadiene). We identify two distinct activation pathways: first, via the formation of neutral intermediate complex [Ir(IMes)(COD)(H2)Cl], and second, via the formation of charged complexes [Ir{+}(IMes) (COD)(H2)R]Cl{-} with bound ligands R = acetonitrile, ammonia, and benzylamine. These ligands originate from substrate choice in the activation process. We conclude that the pathway direction is dominated by solvent polarity. On the basis of this, we develop a protocol for obtaining stable and long-lasting SABRE (Signal Amplification by Reversible Exchange) polarization of an acetonitrile solvent in the presence of a benzylamine coligand. These results are important for better understanding of the chemical dynamics in SABRE systems as well as for the fundamental physics experiments that require large and long-lasting polarization of highly-concentrated molecules (e.g., those from the solvent itself).
- Open Access
- 20 March 2023
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 17 (7) , 6638-6648
Confinement and Exciton Binding Energy Effects on Hot Carrier Cooling in Lead Halide Perovskite Nanomaterials
- 20 March 2023
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 17 (7) , 6638-6648
Open AccessConfinement and Exciton Binding Energy Effects on Hot Carrier Cooling in Lead Halide Perovskite Nanomaterials