Rapid prototyping-coded masks for x-ray backscatter imaging
Open Access
- 22 August 2018
- journal article
- research article
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 57 (08) , 085104-7
Abstract
Coded masks (CM) often lack a self-supporting structure that is difficult to manufacture without recourse to drilled holes in place of ideal square apertures, degrading imaging properties. An alternative approach is presented with three-dimensional (3-D) printed CM molds cast with a radio-opaque material that allows square elements to be retained. Two methods are presented; hot casting a bismuth alloy (density 8.6 g cm − 3) and cold casting with tungsten powder/epoxy resin (densities 9.6 and 10.6 g cm − 3). A critical review of 3-D printed-CM fabrication along with some typical x-ray backscatter images is presented. A signal-to-noise ratio from both the machined tungsten and cold cast 3-D printed mask were comparable, with the former having a slight advantage. Also, 3-D printed cold cast masks were found to be more economical and easier to rapid prototype over traditional drilled tungsten masks.Keywords
Funding Information
- Defence Science and Technology Laboratory (DSTL/JA108256)