Development of an enhanced porosity AgAgCl reference electrode with improved stability
- 1 September 2019
- journal article
- research article
- Published by IOP Publishing in Engineering Research Express
- Vol. 1 (1) , 015039
Abstract
We have developed a new low-cost method for fabrication of an enhanced porosity ultra-low noise silver-silver chloride (Ag-AgCl) reference electrode with dramatically high stability, useful in precise electrochemical and biomedical measurements. Low noise level and high stability are the most important features when evaluating reference electrode for example when used as a half-cell at electrochemical cells. The noise was measured for bare Ag-AgCl electrode pairs in a saline electrolyte without any junction. The noise spectral density for such measurements increases at low frequencies due to flicker (1/f) noise. Thermal noise from the real part of the electrode impedance is always lower than 1/f noise and is shown as offset voltage in noise spectrum. Electrode noise is highly correlated to its offset voltage. Moreover, the variance of the potential difference in our measurements is correlated to the noise level of electrodes. In this paper, offset voltage spectrum and the variance of data while doing measurements are proposed for identification of noise in our electrodes. The results presented suggest a new low-cost process for fabrication of enhanced porosity reference electrodes with nanovolt noise level at 1 Hz, low enough for electrochemical and biomedical measurements.Keywords
This publication has 26 references indexed in Scilit:
- Electromagnetic Attenuation Factor Based NDE Approach for Depth Detection of Hidden Defects Using HTS rf-SQUID2019
- Fast Fourier Transform Based NDT Approach for Depth Detection of Hidden Defects Using HTS rf-SQUIDIEEE Transactions on Applied Superconductivity, 2018
- An AlN-on-Si resonant IR sensor array with a large temperature coefficient of frequency2016
- Fabrication of Micro-Needle Electrodes for Bio-Signal Recording by a Magnetization-Induced Self-Assembly MethodSensors, 2016
- Preparation of porous nanostructured Ag electrodes for sensitive electrochemical detection of hydrogen peroxideElectrochimica Acta, 2016
- A comparative study of electrical potential sensors and Ag/AgCl electrodes for characterising spontaneous and event related electroencephalagram signalsJournal of Neuroscience Methods, 2015
- Defect-depth dependence of optimal frequency and spatial resolution in SQUID based NDE2015
- An ultralow-noise Ag/AgCl electric field sensor with good stability for marine EM applications2013
- Electrodeposition of Cu-Ni Alloy Electrodes with Bimodal Porosity and Their Use for Nitrate ReductionECS Electrochemistry Letters, 2013
- Sensitivities of Key Parameters in the Preparation of Silver/Silver Chloride Electrodes Used in Harned Cell Measurements of pHSensors, 2011