Prediction of fluid responsiveness in mechanically ventilated cardiac surgical patients: the performance of seven different functional hemodynamic parameters
Open Access
- 22 May 2018
- journal article
- research article
- Published by Springer Nature in BMC Anesthesiology
- Vol. 18 (1) , 1-7
Abstract
Functional hemodynamic parameters such as stroke volume and pulse pressure variation (SVV and PPV) have been shown to be reliable predictors of fluid responsiveness in mechanically ventilated patients. Today, different minimally- and non-invasive hemodynamic monitoring systems measure functional hemodynamic parameters. Although some of these parameters are described by the same name, they differ in their measurement technique and thus may provide different results. We aimed to test the performance of seven functional hemodynamic parameters simultaneously in the same clinical setting. Hemodynamic measurements were done in 30 cardiac surgery patients that were mechanically ventilated. Before and after a standardized intravenous fluid bolus, hemodynamics were measured by the following monitoring systems: PiCCOplus (SVVPiCCO, PPVPiCCO), LiDCOrapid (SVVLiDCO, PPVLiDCO), FloTrac (SVVFloTrac), Philips Intellivue (PPVPhilips) and Masimo pulse oximeter (pleth variability index, PVI). Prediction of fluid responsiveness was tested by calculation of receiver operating characteristic (ROC) curves including a gray zone approach and compared using Fisher’s Z-Test. Fluid administration resulted in an increase in cardiac output, while all functional hemodynamic parameters decreased. A wide range of areas under the ROC-curve (AUC’s) was observed: AUC-SVVPiCCO = 0.91, AUC-PPVPiCCO = 0.88, AUC-SVVLiDCO = 0.78, AUC-PPVLiDCO = 0.89, AUC-SVVFloTrac = 0.87, AUC-PPVPhilips = 0.92 and AUC-PVI = 0.68. Optimal threshold values for prediction of fluid responsiveness ranged between 9.5 and 17.5%. Lowest threshold values were observed for SVVLiDCO, highest for PVI. All functional hemodynamic parameters tested except for PVI showed that their use allows a reliable identification of potential fluid responders. PVI however, may not be suitable after cardiac surgery to predict fluid responsiveness. NCT02571465 , registered on October 7th, 2015 (retrospectively registered).Keywords
This publication has 25 references indexed in Scilit:
- The estimation of cardiac output by the Nexfin device is of poor reliability for tracking the effects of a fluid challengeCritical Care, 2012
- Assessing the Diagnostic Accuracy of Pulse Pressure Variations for the Prediction of Fluid ResponsivenessAnesthesiology, 2011
- Cardiac output monitoring: an integrative perspectiveCritical Care, 2011
- pROC: an open-source package for R and S+ to analyze and compare ROC curvesBMC Bioinformatics, 2011
- Cross-comparison of cardiac output trending accuracy of LiDCO, PiCCO, FloTrac and pulmonary artery cathetersCritical Care, 2010
- Minimally Invasive Measurement of Cardiac Output during Surgery and Critical CareAnesthesiology, 2010
- The PiCCO MonitorInternational Anesthesiology Clinics, 2010
- Dynamic changes in arterial waveform derived variables and fluid responsiveness in mechanically ventilated patients: A systematic review of the literature*Critical Care Medicine, 2009
- Cardiac filling pressures are not appropriate to predict hemodynamic response to volume challenge*Critical Care Medicine, 2007
- EuroSCORE: a systematic review of international performanceEuropean Journal of Cardio-Thoracic Surgery, 2004