Process-Induced Deformations on Composite L-Shaped Part: Numerical Prediction and Compensated Mould Design
Open Access
- 10 April 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1182, 83-90
Abstract
This work investigates the formation and control of residual deformations in composite L-shaped parts manufactured by autoclave curing. An experimental study is first conducted to characterize spring-in for different stacking sequences. Dimensional measurements are performed using stereo digital image correlation to quantify spring-in and to assess the presence of warpage along the flanges. A numerical study is then carried out to develop a simulation method for process-induced deformation prediction. The influence of the main mechanisms involved is analyzed, and a modeling strategy for the tool-part interaction is proposed. Finally, compensated mould design is addressed. The convergence of the optimization problem is investigated, and an optimized mold geometry is determined for each part considered in this study.Keywords
This publication has 12 references indexed in Scilit:
- Review of monolithic composite laminate and stiffened structures in aeronautic applicationsComposites Part C: Open Access, 2025
- Past, present and future prospective of global carbon fibre composite developments and applicationsComposites Part B: Engineering, 2022
- Experimental study and in-situ FBG monitoring of process-induced strains during autoclave co-curing, co-bonding and secondary bonding of composite laminatesComposites Part A: Applied Science and Manufacturing, 2021
- Effects of pulling speed on structural performance of L-shaped pultruded profilesComposite Structures, 2021
- Compensating process-induced distortions of composite structures: A short communicationComposite Structures, 2018
- Modelling of the spring-in phenomenon in curved parts made of a thermosetting compositeComposites Part A: Applied Science and Manufacturing, 2010
- Development of the properties of a carbon fibre reinforced thermosetting composite through cureComposites Part A: Applied Science and Manufacturing, 2010
- Mechanisms generating residual stresses and distortion during manufacture of polymer–matrix composite structuresComposites Part A: Applied Science and Manufacturing, 2006
- Tool–part interaction in composites processing. Part I: experimental investigation and analytical modelComposites Part A: Applied Science and Manufacturing, 2004
- In-situ measurement of chemical shrinkage of MY750 epoxy resin by a novel gravimetric methodComposites Science and Technology, 2004