Prediction of Flame‐Spread on Horizontal Combustibles
- 12 April 2026
- journal article
- Published by Wiley in Fire and Materials
- Vol. 50 (4) , 430-438
Abstract
The flame spread behavior of horizontal combustibles such as pocket coil mattresses in residential houses was investigated under various installation height conditions, and an existing predictive model was refined. In a series of experiments, mattresses were tested with diverse installation heights (ranging from 0 to 515 mm) using the standard ignition source specified by ISO 12949:2011. The experimental results revealed that both the fire growth rate and the maximum heat release rate increased with higher mattress installation height. During combustion, molten material and mattress fragments descended and ignited on the floor. The flames associated with the combustion on the floor affected the combustion of the mattress body, leading to a correlation between higher mattress installation height and increased heat release rates and fire growth rates. Traditionally, flame spread speed is determined by the incident heat flux to the horizontal and upper surfaces of the solid combustible material adjacent to the flame. However, a modified model was proposed that accounts for the influence of both convective and radiant heat fluxes generated by the flames on the floor, impacting the cross‐section of the burning mattress body.Keywords
Funding Information
- Korea Institute of Energy Technology Evaluation and Planning (20224B10200110)
- National Research Foundation of Korea (2023R1A2C2003175)
- Ministry of Trade, Industry and Energy
This publication has 10 references indexed in Scilit:
- Fire Properties of Bed Mattresses Focusing on the Fire Growth Rate and Flame HeightMaterials, 2022
- Flame Spread Mechanism through Analysis of Fire Behavior of Bed Mattress by the ISO 12949 TestJournal of Asian Architecture and Building Engineering, 2015
- Experimental study of horizontal flame spread over rigid polyurethane foam on a plateau: effects of sample width and ambient pressureFire and Materials, 2014
- Heat transfer mechanisms in horizontal flame spread over wood and extruded polystyrene surfacesInternational Journal of Heat and Mass Transfer, 2013
- An Introduction to Fire Dynamics2011
- Experimental study on the characteristics of horizontal flame spread over XPS surface on plateauJournal of Hazardous Materials, 2011
- Width effects on the early stage of upward flame spread over PMMA slabs: Experimental observationsFire Safety Journal, 2009
- Upward flame spread on a vertically oriented fuel surface: The effect of finite widthProceedings of the Combustion Institute, 2007
- Flammability tests for upholstered furniture and mattresses2006
- Purely buoyant diffusion flames :1979