A Uniformity Coefficient-Based Method for Improving the Wear Resistance of Mold Ejector Pin Guide Holes via Oblique Laser Shock Peening
Open Access
Abstract
To address the severe wear of the hole wall and orifice in ejector pin guide holes of injection molds caused by frequent hole-shaft sliding, this study proposes a composite strengthening method that combines nitriding with oblique laser shock peening (N-OLSP). The strengthening uniformity in both circumferential and axial directions was evaluated by defining a laser shock peening uniformity coefficient (). By strictly controlling the uniformity coefficient ratio of two adjacent spots to be no less than 0.98, the optimal step angles for circumferential and axial directions were determined. Comparative experiments were conducted on three types of samples: Untreated, Nitrided, and N-OLSP treated. The results demonstrate that N-OLSP significantly enhances both surface hardness and residual compressive stress of the guide hole, and the degree of improvement increases with a higher value of . Among the tested samples, N-OLSP exhibited the best wear resistance at the orifice, reducing the wear rate to 0.60 μm/h. Compared with the untreated and nitrided samples, the wear rate reduction achieved by N-OLSP was 66.85% and 16.67%, respectively.
Keywords
Funding Information
- National Natural Science Foundation of China (52475459)
- Public Technical Service Platform of Xiamen Science and Technology Bureau (3502Z20231001)
- Major Science and Technology Project of Fujian, China (B2023347)
- Synergetic Innovation Special Program of Fuxiaquan National Independent Innovation Demonstration Zone (3502ZCQXT2023009)
- Fund of Jimei University for Research Start-up (ZQ2024032)
This publication has 24 references indexed in Scilit:
- Thermal Stability of Nanocrystals in SLM-printed Ti64 Alloy Treated by Laser Shock Peening and Plasma NitridingMetals and Materials International, 2024
- Effect of supersonic fine particle bombardment on microstructure evolution and tribological properties of GCr15SiMn bearing steelJournal of Materials Research and Technology, 2023
- Wear resistance of AISI 5140 steel with Micro-laser shock peeningMaterials Letters, 2023
- Corrosion failure analysis of a cooling system of an injection moldEngineering Failure Analysis, 2022
- Microstructure and mechanical properties of laser shock peened 38CrSi steelMaterials Science and Engineering: A, 2020
- Strain-induced formation of a gradient nanostructured surface layer on an ultrahigh strength bearing steelJournal of Materials Science & Technology, 2018
- Friction and wear on laser textured Ti6Al4V surface subjected to laser shock peening with contacting foilOptics & Laser Technology, 2018
- Effect of nitrided-layer microstructure control on wear behavior of AISI H13 hot work die steelApplied Surface Science, 2018
- Effect of laser shock processing on fatigue life of 2205 duplex stainless steel notched specimensOptics & Laser Technology, 2017
- Effects of multiple laser shock processing (LSP) impacts on mechanical properties and wear behaviors of AISI 8620 steelMaterials Science and Engineering: A, 2012