YLYin Li

Yin Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yin Li has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Uniformity Coefficient-Based Method for Improving the Wear Resistance of Mold Ejector Pin Guide Holes via Oblique Laser Shock Peening

    by Enfu Liu, Yueying Ye, Yudie Zhang, Shixu Mu, Zhilong Xu, Wenjun Jiang, Yin Li

    To address the severe wear of the hole wall and orifice in ejector pin guide holes of injection molds caused by frequent hole-shaft sliding, this study proposes a composite strengthening method that combines nitriding with oblique laser shock peening (N-OLSP). The strengthening uniformity in both circumferential and axial directions was evaluated by defining a laser shock peening uniformity coefficient (k). By strictly controlling the uniformity coefficient ratio of two adjacent spots to be no less than 0.98, the optimal step angles for circumferential and axial directions were determined. Comparative experiments were conducted on three types of samples: Untreated, Nitrided, and N-OLSP treated. The results demonstrate that N-OLSP significantly enhances both surface hardness and residual compressive stress of the guide hole, and the degree of improvement increases with a higher value of k. Among the tested samples, N-OLSP exhibited the best wear resistance at the orifice, reducing the wear rate to 0.60 μm/h. Compared with the untreated and nitrided samples, the wear rate reduction achieved by N-OLSP was 66.85% and 16.67%, respectively.

  • Open Access

    The Effects of Different Ultrasonic Composite Surface Modifications on the Properties of H13 Steel for Shield Tunnel Machine Cutter Ring

    by Xiuyu Chen, Yalong Li, Longhui Li, Huanbin Xu, Yi Li, Zhilong Xu, Qingshan Jiang, Shixu Mu, Yin Li, Heng Liu

    Tunnel boring machines (TBMs) are exposed to the impact of the ground shattering force and the friction of sandstone during excavation work, and are prone to wear and breakage, and other failures. Traditional heat treatment processes cannot simultaneously achieve the required high-energy composite structure of hard external and tough internal properties for cutter rings, leading to inadequate wear resistance and impact toughness under working conditions. This study utilizes H13 steel as the base material, and based on a study of carburizing, nitriding, and ultrasonic impact processes for H13 steel analyzing the effects of different high-energy composite modification processes on the hardness distribution, microstructure, and residual stress of H13 steel, the mechanisms by which high-energy composite modification processes affect the wear resistance and impact resistance of H13 steel are revealed. The results indicate that the wear amount and impact toughness of the sample subjected to carburizing and ultrasonic surface rolling composite strengthening were 1.9 mg and 27.34 J/cm2, demonstrating the best wear and impact resistance. This combination of properties allows the H13 steel cutter ring to achieve the optimal overall performance in terms of wear resistance and impact resistance.