A new model of time evolution of gate leakage current after soft breakdown in ultra-thin gate oxides
Authors:
- 25 June 2003
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 155-158
Abstract
The post-SBD degradation of ultra-thin gate oxides is investigated by means of experiments, theoretical modeling, and computer simulations. The gate leakage current after SBD increases gradually, and is finally limited by the parasitic resistance. A newly developed model shows that the gate leakage increase of post-SBD MOSFETs even under operating conditions causes a significant impact on LSIs in terms of the power consumption.Keywords
This publication has 10 references indexed in Scilit:
- Point contact conduction at the oxide breakdown of MOS devices2002
- Voltage Acceleration of Ultra-Thin Gate Oxide Degradation before and after Soft Breakdown2002
- Consistent model for short-channel nMOSFET after hard gate oxide breakdownIEEE Transactions on Electron Devices, 2002
- Impact of MOSFET gate oxide breakdown on digital circuit operation and reliabilityIEEE Transactions on Electron Devices, 2002
- Ultra-thin gate oxide reliability projectionsSolid-State Electronics, 2002
- Reduction of thermal damage in ultrathin gate oxides after intrinsic dielectric breakdownApplied Physics Letters, 2001
- The gate oxide lifetime limited by `B-mode' stress induced leakage current and the scaling limit of silicon dioxides in the direct tunnelling regimeSemiconductor Science and Technology, 2000
- Experimental study of the quasi-breakdown failure mechanism in 4.5 nm-thick SiO2 oxidesMicroelectronics Reliability, 1999
- Definition of dielectric breakdown for ultra thin (<2 nm) gate oxidesSolid-State Electronics, 1997
- Hole Injection in Germanium-Quantitative Studies and Filamentary Transistors*Bell System Technical Journal, 1949