Roughness and Unit Side Resistances of Drilled Shafts Socketed in Clay Shale and Limestone
- 1 September 2008
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 134 (9) , 1272-1279
Abstract
Rock socketed drilled shafts are being used increasingly to support heavily loaded structures. Rock sockets provide resistance to the load through a combination of side and base resistances. In this study, the effect of drilling tools such as an auger and a core barrel on the unit side resistance was investigated. A total of four field studies were performed on clay shale (compressive strength of 1–2 MPa ) and limestone (compressive strength of 10 MPa ). Borehole roughnesses produced by the different types of drilling tools in clay shale and limestone were measured using a laser borehole roughness profiler developed in this study to measure roughness to 0.5 mm in the boreholes. Based on the results of this study, it was observed that the drilling tools developed different socket roughnesses, which in turn affected the side resistances of the rock socketed drilled shafts.Keywords
This publication has 5 references indexed in Scilit:
- A new socket roughness factor for prediction of rock socket shaft resistanceCanadian Geotechnical Journal, 2001
- Requirements for accurate quantification of self-affine roughness using the roughness–length methodInternational Journal of Rock Mechanics and Mining Sciences, 1999
- A simple method to estimate the fractal dimension of a self‐affine seriesGeophysical Research Letters, 1990
- A design method for drilled piers in soft rockCanadian Geotechnical Journal, 1987
- Methods of improving the performance of drilled piers in weak rockCanadian Geotechnical Journal, 1983