Detecting Critical Crevice Temperature for Duplex Stainless Steels in Chloride Solutions
Authors:
- D. HanDHD. Han
- Y. JiangYJY. Jiang
- B. DengBDB. Deng
- L. ZhangLZL. Zhang
- J. GaoJGJ. Gao
- H. TanHTH. Tan
- J. LiJLJ. Li
- 1 February 2011
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 67 (2) , 025004-1
Abstract
A simple and rapid electrochemical method for the evaluation of crevice corrosion in duplex stainless steels (DSS) is described. Three types of DSS—namely, UNS S32101, UNS S31803, and UNS S32750—were tested in 1 mol/L sodium chloride (NaCl) solutions. Results showed good reproducibility with a typical standard deviation of below 3°C. The critical pitting temperature (CPT) for the same specimens was also investigated in 1 mol/L NaCl solutions. An approximately 20°C decrease from CPT to critical crevice temperature (CCT) was observed and subsequently explained. Then, the morphologies of crevice corrosion were studied using scanning electron microscopy with energy-dispersive x-ray spectroscopy (SEM/EDS) method. The SEM/EDS study revealed that the ferrite phase was the site where preferential dissolution took place at the initiation step of crevice corrosion, which was in accordance with the prediction by calculating the critical crevice index. Moreover, repassivation was detected with the development of crevice corrosion. The reason was clarified by combining the results obtained with a successful diffusion model, and eventually the crevice corrosion progress was illustrated schematically.Keywords
This publication has 19 references indexed in Scilit:
- Effect of annealing temperature on the pitting corrosion resistance of super duplex stainless steel UNS S32750Materials Characterization, 2009
- Crevice corrosion cathodic reactions and crevice scaling lawsElectrochimica Acta, 2009
- Transport processes in steam generator crevicesCorrosion Science, 2002
- Influence of pH and Chloride Concentration on the Pitting and Crevice Corrosion Behavior of High-Alloy Stainless SteelsCorrosion, 2000
- Surface characterisation and crevice corrosion behaviour of nickel-based alloys in the paper industryJournal of Solid State Electrochemistry, 2000
- Electrochemical Evaluation of Crevice Corrosion in Stainless SteelsMaterials Science Forum, 1998
- The initiation of crevice corrosion in stainless steelsCorrosion Science, 1997
- Critical Crevice Temperature for High-Alloyed Stainless Steels in Chlorinated Seawater ApplicationsCorrosion, 1997
- Crevice Corrosion Repassivation Temperatures of Highly Alloyed Stainless SteelsCorrosion, 1995
- Temperature as a Crevice Corrosion CriterionCorrosion, 1974