Development of a Client-Server Communication Method for Matlab/ Simulink Based Remote Robotics Experiments
- 1 July 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4 (21635137) , 3201-3206
Abstract
This paper describes the development of a client-server communication method using the TCP/IP protocol to run Matlab/Simulink compatible motion control units operating on the remote server side. The developed method is currently in use to allow access to a hardware-in-the-loop (HIL) robot simulator developed for both on-site and remote use at the Control Laboratory in the University of Alaska Fairbanks (UAF). The client-server communication is developed in C/C++ using wxWidgets to communicate with the Matlab/Simulink downloadable DS1104, which is used to develop a variety of robot dynamics configurations and control algorithms on the robotic simulator. Practical case study results from a remotely conducted graduate robotics project are also presented in relation to a HIL simulator developed for the real-time simulation of PUMA-type robots. The UAF remote laboratory Web site can be accessed at: http://www.uaf.edu/ece/remote-roboticsKeywords
This publication has 5 references indexed in Scilit:
- Web-Based Command Shaping of Cobra 600 Robot With a Swinging LoadIEEE Transactions on Industrial Informatics, 2006
- Hardware in the loop simulation of robot manipulators through Internet in mechatronics education2003
- Breaking the lab's walls. Tele-laboratories at the University of Pisa2001
- A Web-based system for control engineering education2000
- Effectiveness calculations in captive-carry HIL missile simulator experimentsIEEE Transactions on Aerospace and Electronic Systems, 1998