Voltage Fed and Current Fed Full Bridge Converter for the Use in Three Phase Grid Connected Fuel Cell Systems
- 1 January 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 1-7
Abstract
Fuel cells for low or medium power deliver comparatively low voltages compared to the mains voltage at high currents. A high dc-link voltage is needed to feed in electrical energy from fuel cells to the mains via a voltage source inverter. Several well known DC/DC converters can be used to transform the varying fuel cell voltage to the requested amplitude of the dc-link-voltage. Besides transformerless converters like the boost converter, converters with high frequency transformers can be used. In the considered higher power range, the full-bridge converter circuit is the appropriate solution. Depending on their input circuit, the converters are classified between voltage fed and current fed full bridge converter. In this paper, full bridge converters of the voltage type and of the current type as active front end for fuel cell inverters in the power range of 20 kW and higher are analysed and compared to each other. The focus is set on the operating behavior, the system complexity and the efficiency of the different convertersKeywords
This publication has 6 references indexed in Scilit:
- The influence of power electronic dynamics on PEM fuel cell-system2005
- Comparison of three phase current source inverters and voltage source inverters linked with DC to DC boost converters for fuel cell generation systems2005
- Topologies of Single-Phase Inverters for Small Distributed Power Generators: An OverviewIEEE Transactions on Power Electronics, 2004
- A new green power inverter for fuel cells2003
- Full-bridge isolated current fed converter with active clamp1999
- Design considerations for high-voltage high-power full-bridge zero-voltage-switched PWM converter1990