A Global Approach to Turbomachinery Flow Control: Passage Vortex Control
- 26 September 2013
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 136 (4) , 041003
Abstract
A flow control scheme was implemented in a low-pressure turbine cascade that simultaneously mitigated profile and endwall losses using midspan vortex generator jets (VGJs) and endwall suction. The combined system had an approximate zero-net mass flux. During the design, a theoretical model was used that effectively predicted the trajectory of the passage vortex using inviscid results obtained from two-dimensional computational fluid dynamics (CFD). The model was used in the design of two flow control approaches: the removal and redirection approaches. The emphasis of the removal approach was the direct application of flow control along the passage vortex (PV) trajectory. The redirection approach attempted to alter the trajectory of the PV with the judicious placement of suction holes. A potential flow model was created to aid in the design of the redirection approach. The model results were validated using flow visualization and particle image velocimetry (PIV) in a linear turbine cascade. Detailed total pressure loss wake surveys were measured while matching the suction and VGJ mass flow rates for the removal and redirection approaches at ReCx = 25,000 and blowing ratio, B, of 2. When compared with the no control results, the addition of VGJs and endwall suction reduced the wake losses by 69% (removal) and 68% (redirection). The majority of the total pressure loss reduction resulted from the spanwise VGJs, while the suction schemes provided modest additional reductions (<2%). At ReCx = 50,000, the endwall control effectiveness was assessed for a range of suction rates without midspan VGJs. Area-averaged total pressure loss reductions of up to 28% were measured in the wake at ReCx = 50,000, B = 0, with applied endwall suction (compared to no suction at ReCx = 50,000), at which point the loss core of the PV was almost completely eliminated.Keywords
This publication has 21 references indexed in Scilit:
- Computational Design and Experimental Evaluation of Using a Leading Edge Fillet on a Gas Turbine VaneJournal of Turbomachinery, 2002
- Secondary Flow Measurements in a Turbine Passage With Endwall Flow ModificationJournal of Turbomachinery, 2000
- Control of 3D turbulent boundary layer separation caused by a wing–body junctionExperimental Thermal and Fluid Science, 1998
- Flow Visualization in a Linear Turbine Cascade of High Performance Turbine BladesJournal of Turbomachinery, 1997
- Effects of a leading-edge fillet on the flow past an appendage-body junctionAIAA Journal, 1992
- Suppression of the wing-body junction vortex by body surface suctionJournal of Aircraft, 1992
- Effects of a fillet on the flow past a wing-body junctionAIAA Journal, 1990
- Turbulent Transport on the Endwall in the Region Between Adjacent Turbine BladesJournal of Heat Transfer, 1988
- Predictions of Endwall Losses and Secondary Flows in Axial Flow Turbine CascadesJournal of Turbomachinery, 1987
- Three-Dimensional Flow Within a Turbine Cascade PassageJournal of Engineering for Power, 1977