An On-Chip Monitoring Circuit for Signal-Integrity Analysis of 8-Gb/s Chip-to-Chip Interfaces With Source-Synchronous Clock
- 4 January 2017
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 25 (4) , 1386-1396
Abstract
This paper presents an on-chip monitoring circuit (OCMC) for analyzing the signal integrity of high-speed signals for a chip-to-chip interface with a source-synchronous clocking scheme. The proposed OCMC consists of a fractional-N phase-locked loop (PLL)-based frequency synthesizer, a high-bandwidth track-and-hold circuit, and a 10-bit analog-to-digital converter (ADC) to implement a subsampling scheme. The proposed fractional-N PLL-based frequency synthesizer improves the time jitter accumulated in a voltage-controlled oscillator using a fractional frequency divider operated by an eight-phase clock. The bandwidth of the track-and-hold circuit is designed to be 6 GHz, using inductive peaking realized through a source follower. The OCMC samples 49 points over two unit intervals of a high-speed input signal when the frequency multiplication of the frequency synthesizer is 6.125/6. The 10-bit ADC uses the architecture of a pipelined successive approximation register ADC to reduce the power consumption and chip area. The proposed OCMC is implemented with 65-nm CMOS technology and a 1.2 V supply. The 8-Gb/s chip-to-chip interface signal is reconstructed with time and voltage resolutions of 5.1 ps and 1.17 mV, respectively.Keywords
Funding Information
- Ministry of Science, ICT, and Future Planning, South Korea, under the Information Technology Research Center support program (IITP-2016-H8601-16-1011)
- Institute for Information & communications Technology Promotion
- Basic Science Research Program through NRF funded by the Ministry of Education (2013R1A1A4A01012914)
- IDEC
This publication has 17 references indexed in Scilit:
- 30.8 A 30GS/s double-switching track-and-hold amplifier with 19dBm IIP3 in an InP BiCMOS technology2014
- A 1.7 mW 11b 250 MS/s 2-Times Interleaved Fully Dynamic Pipelined SAR ADC in 40 nm Digital CMOSIEEE Journal of Solid-State Circuits, 2012
- An 8x 10-Gb/s Source-Synchronous I/O System Based on High-Density Silicon Carrier InterconnectsIEEE Journal of Solid-State Circuits, 2012
- A 5.5-GHz 1-mW Full-Modulus-Range Programmable Frequency Divider in 90-nm CMOS ProcessIEEE Transactions on Circuits and Systems II: Express Briefs, 2011
- A 0.65-V 2.5-GHz Fractional-N Synthesizer With Two-Point 2-Mb/s GFSK Data ModulationIEEE Journal of Solid-State Circuits, 2009
- Jitter Analysis and a Benchmarking Figure-of-Merit for Phase-Locked LoopsIEEE Transactions on Circuits and Systems II: Express Briefs, 2009
- Spurious Tone Suppression Techniques Applied to a Wide-Bandwidth 2.4 GHz Fractional-N PLLIEEE Journal of Solid-State Circuits, 2008
- A Multigigahertz Multimodulus Frequency Divider in 90-nm CMOSIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2006
- A 1-MHZ Bandwidth 3.6-GHz 0.18-$muhbox m$CMOS Fractional-N Synthesizer Utilizing a Hybrid PFD/DAC Structure for Reduced Broadband Phase NoiseIEEE Journal of Solid-State Circuits, 2006
- An 8-Gb/s simultaneous bidirectional link with on-die waveform captureIEEE Journal of Solid-State Circuits, 2003