Hyun-Bae Lee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hyun-Bae Lee has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Byeongseon Ko
Department of Memory Division, SK Hynix, Icheon, South Korea
1 shared publication- Daeho Yun
Department of Electrical and Computer Engineering and the Inter-University Semiconductor Research Center, Seoul National University, Seoul, South Korea
1 shared publication - Deog-Kyoon Jeong
Department of Electrical and Computer Engineering, Seoul National University, Seoul, South Korea
1 shared publication Eonhui Lee
Department of Electrical and Computer Engineering and the Inter-University Semiconductor Research Center, Seoul National University, Seoul, South Korea
1 shared publication- Han-Yeol Lee
Department of Electronic Engineering, Kumoh National Institute of Technology, Gumi, South Korea
1 shared publication - Jihee Kim
Inter-University Semiconductor Research Center Seoul National University,Department of Electrical and Computer Engineering,Seoul,Korea
1 shared publication
Latest Publications
- 28 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 69 (9) , 3749-3753
A 32-Gb/s PAM4-Binary Bridge With Sampler Offset Cancellation for Memory Testing
This brief presents a 32-Gb/s PAM4-Binary bridge for the next-generation memory testing. The bridge incorporates all the required functions to evaluate a high-speed PAM4 memory using a low-speed NRZ tester. The low-speed data transmitted from the NRZ tester to the bridge are converted into high-speed PAM4 data through half-rate clock control and forwarded to the memory, and vice-versa. The ground-terminated PAM4 driver provides the single-ended output by controlling the output current with a 2-tap feed-forward equalizer, achieving a ratio level mismatch (RLM) of 0.95. To minimize the offset at the PAM4 receiver, the offset cancellation circuit with an offset of 2.76mV consisting of a CTLE and sampling latches is employed, and the horizontal margin of the received PAM4 signal is 50% for BER<10-9. An all-digital PLL integrated in the bridge doubles the 4-GHz WCK used as forwarded clock for the graphic memory. The count-based PAM4 eye-opening monitor is also proposed to find the optimal codes for the maximum eye opening using the PRBS7 data sequence. The bridge fabricated in the 40-nm CMOS technology occupies an active area of 1.6mm2 and dissipates 132mW.
- 28 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 69 (9) , 3749-3753
A 32-Gb/s PAM4-Binary Bridge With Sampler Offset Cancellation for Memory Testing
This brief presents a 32-Gb/s PAM4-Binary bridge for the next-generation memory testing. The bridge incorporates all the required functions to evaluate a high-speed PAM4 memory using a low-speed NRZ tester. The low-speed data transmitted from the NRZ tester to the bridge are converted into high-speed PAM4 data through half-rate clock control and forwarded to the memory, and vice-versa. The ground-terminated PAM4 driver provides the single-ended output by controlling the output current with a 2-tap feed-forward equalizer, achieving a ratio level mismatch (RLM) of 0.95. To minimize the offset at the PAM4 receiver, the offset cancellation circuit with an offset of 2.76mV consisting of a CTLE and sampling latches is employed, and the horizontal margin of the received PAM4 signal is 50% for BER<10-9. An all-digital PLL integrated in the bridge doubles the 4-GHz WCK used as forwarded clock for the graphic memory. The count-based PAM4 eye-opening monitor is also proposed to find the optimal codes for the maximum eye opening using the PRBS7 data sequence. The bridge fabricated in the 40-nm CMOS technology occupies an active area of 1.6mm2 and dissipates 132mW.
- 4 January 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 25 (4) , 1386-1396
An On-Chip Monitoring Circuit for Signal-Integrity Analysis of 8-Gb/s Chip-to-Chip Interfaces With Source-Synchronous Clock
This paper presents an on-chip monitoring circuit (OCMC) for analyzing the signal integrity of high-speed signals for a chip-to-chip interface with a source-synchronous clocking scheme. The proposed OCMC consists of a fractional-N phase-locked loop (PLL)-based frequency synthesizer, a high-bandwidth track-and-hold circuit, and a 10-bit analog-to-digital converter (ADC) to implement a subsampling scheme. The proposed fractional-N PLL-based frequency synthesizer improves the time jitter accumulated in a voltage-controlled oscillator using a fractional frequency divider operated by an eight-phase clock. The bandwidth of the track-and-hold circuit is designed to be 6 GHz, using inductive peaking realized through a source follower. The OCMC samples 49 points over two unit intervals of a high-speed input signal when the frequency multiplication of the frequency synthesizer is 6.125/6. The 10-bit ADC uses the architecture of a pipelined successive approximation register ADC to reduce the power consumption and chip area. The proposed OCMC is implemented with 65-nm CMOS technology and a 1.2 V supply. The 8-Gb/s chip-to-chip interface signal is reconstructed with time and voltage resolutions of 5.1 ps and 1.17 mV, respectively.
- 4 January 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 25 (4) , 1386-1396
An On-Chip Monitoring Circuit for Signal-Integrity Analysis of 8-Gb/s Chip-to-Chip Interfaces With Source-Synchronous Clock
This paper presents an on-chip monitoring circuit (OCMC) for analyzing the signal integrity of high-speed signals for a chip-to-chip interface with a source-synchronous clocking scheme. The proposed OCMC consists of a fractional-N phase-locked loop (PLL)-based frequency synthesizer, a high-bandwidth track-and-hold circuit, and a 10-bit analog-to-digital converter (ADC) to implement a subsampling scheme. The proposed fractional-N PLL-based frequency synthesizer improves the time jitter accumulated in a voltage-controlled oscillator using a fractional frequency divider operated by an eight-phase clock. The bandwidth of the track-and-hold circuit is designed to be 6 GHz, using inductive peaking realized through a source follower. The OCMC samples 49 points over two unit intervals of a high-speed input signal when the frequency multiplication of the frequency synthesizer is 6.125/6. The 10-bit ADC uses the architecture of a pipelined successive approximation register ADC to reduce the power consumption and chip area. The proposed OCMC is implemented with 65-nm CMOS technology and a 1.2 V supply. The 8-Gb/s chip-to-chip interface signal is reconstructed with time and voltage resolutions of 5.1 ps and 1.17 mV, respectively.