Model and simulation for melt flow in micro-injection molding based on the PTT model
Authors:
- 21 September 2011
- journal article
- Published by IOP Publishing in Modelling and Simulation in Materials Science and Engineering
- Vol. 19 (8) , 085003
Abstract
Unsteady viscoelastic flows were studied using the finite element method in this work. The Phan-Thien–Tanner (PTT) model was used to represent the rheological behavior of viscoelastic fluids. To effectively describe the microscale effects, the slip boundary condition and surface tension were added to the mathematical model for melt flow in micro-injection molding. The new variational equation of pressure, including the viscoelastic parameters and slip boundary condition, was generalized using integration by parts. A computer code based on the finite element method and finite difference method was developed to solve the melt flow problem. Numerical simulation revealed that the melt viscoelasticity plays an important role in the prediction of melt pressure, temperature at the gate and the succeeding melt front advancement in the cavity. Using the viscoelastic model one can also control the rapid increase in simulated pressure, temperature, and reduce the filling difference among different cavities. The short shot experiments of micro-motor shaft showed that the predicted melt front from the viscoelastic model is in fair agreement with the corresponding experimental results.Keywords
This publication has 22 references indexed in Scilit:
- Multi-scale filling simulation of micro-injection molding processJournal of Mechanical Science and Technology, 2011
- Analysis of the filling capability to the microstructures in micro-injection moldingApplied Mathematical Modelling, 2009
- Study on micro-injection molding of light guiding plate by numerical simulationInternational Communications in Heat and Mass Transfer, 2008
- Analysis for microstructure of microlens arrays on micro-injection molding by numerical simulationInternational Communications in Heat and Mass Transfer, 2008
- Microinjection molding of thermoplastic polymers: a reviewJournal of Micromechanics and Microengineering, 2007
- Modelling and experimental verification of pressure prediction in the in-mould coating (IMC) process for injection moulded partsModelling and Simulation in Materials Science and Engineering, 2007
- Three‐dimensional numerical simulation of injection molding filling of optical lens and multiscale geometry using finite element methodPolymer Engineering & Science, 2006
- Simulation of the filling process in micro channels for polymeric materialsJournal of Micromechanics and Microengineering, 2002
- Micro-channel filling flow considering surface tension effectJournal of Micromechanics and Microengineering, 2002
- VISCOELASTIC MODELLING OF ENTRANCE FLOW USING MULTIMODE LEONOV MODELInternational Journal for Numerical Methods in Fluids, 1997