Facile Preparation of Porous CaMgAl Hydrotalcite-Like Derived Mixed Oxides through Alkaline Etching of KOH for CO2 Capture
- 1 July 2022
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry A
- Vol. 96 (7) , 1555-1560
Abstract
Hydrotalcite-like compounds are effective adsorbents for adsorbing and separating CO2 from flue gas. However, this kind of adsorbents has the problems of poor dispersibility and low available specific surface area. In response to these problems, porous CaMgAl mixed oxides were obtained by KOH alkaline etching of CaMgAl hydrotalcite-like hydroxides prepared by one-pot hydrothermal method. The characterization results demonstrated that after alkaline etching, the Al species were partly removed and some mesopores were formed, along with the increase of the specific surface area. Correspondingly, the CO2 uptake of the alkaline-etched adsorbent was up to 380.7 mg/g, ascribed to the developed pore structure. The porous structure facilitated the exposure of alkaline adsorption active sites and made it easier to combine CO2 molecules with adsorption sites on the adsorbent surface. Besides, the alkaline-etched adsorbent had a good cyclic stability after 10 cycles with maintaining 78% of the initial CO2 uptake, which was potentially applied for CO2 capture.Keywords
This publication has 29 references indexed in Scilit:
- Preparation of MgO-coated nano CaO using adsorption phase reaction technique for CO2sorptionRSC Advances, 2016
- Hydrogenolysis of glycerol to propanediols on Cu–Ca–Al hydrotalcites derived catalystsReaction Kinetics, Mechanisms and Catalysis, 2015
- Effect of Cerium Oxide Doping on the Performance of CaO-Based Sorbents during Calcium Looping CyclesEnvironmental Science & Technology, 2015
- A review on solid adsorbents for carbon dioxide captureJournal of Industrial and Engineering Chemistry, 2015
- Cerium Promoted Nano Nickel Catalysts Ni-Ce/CNTs and Ni-Ce/Al2O3for CO2MethanationIntegrated Ferroelectrics, 2014
- The role of different properties of activated carbon in CO2 adsorptionChemical Engineering Journal, 2013
- Effect of Support Material on Carbonation and Sulfation of Synthetic CaO-Based Sorbents in Calcium Looping CycleEnergy & Fuels, 2013
- Enhanced CO2 adsorption capacity and stability using CaO‐based adsorbents treated by hydrationAIChE Journal, 2013
- CO2 mineralization induced by fungal nitrate assimilationBioresource Technology, 2011
- High temperature adsorption of carbon dioxide on Cu–Al hydrotalcite-derived mixed oxides: kinetics and equilibria by thermogravimetryJournal of Thermal Analysis and Calorimetry, 2009