Cathode: the Key Factor in Vacuum Breakdown
Authors:
- 1 September 2018
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 59-62
Abstract
The objective of this paper is to prove that the cathode is the key factor in vacuum breakdown. Three identical groups (I, II and III) of electrodes were prepared. Each group contained two pairs of plane-plane copper electrodes, pair A and B. In each group, the two pairs of electrodes were firstly applied the conditioning process of impulse voltage. Afterward, pair C was arranged by a combination of cathode of pair A and B, pair A cathode- pair B cathode. Pair D was arranged by a combination of anode of pair A and B, pair A anode- pair B anode. The arrangement was under the vacuum condition without exposure of air condition. Surface-analysis of the electrode surfaces were done before and after the vacuum breakdown test for pair A and B by X-ray photoelectron spectroscopy (XPS). The breakdown test and surface analysis were repeated to new combined electrode pairs, pair C and D, again to check the breakdown characteristic of the two new pairs of electrodes. All the three group results showed that after the conditioning saturation, no XPS result difference existed among pair A, B C and D. The breakdown electric fields of pair B and C (sharing the same cathode) were nearly the same, suggesting the cathode influence the breakdown electric field. The breakdown electric field of pair D was obvious higher than that of pair A. The only difference between pair A and D is the cathode. The results may provide a further understanding about the factor of the anode and cathode in the vacuum breakdown test.Keywords
This publication has 4 references indexed in Scilit:
- Influence of arc-melted cathode layer depth on vacuum insulationIEEE Transactions on Dielectrics and Electrical Insulation, 2017
- Research on vacuum insulation properties — In situ measurements and surface analysis2016
- Vacuum electrical breakdown characteristics and surface condition of ti electrodes with oxidation conditionsIEEE Transactions on Dielectrics and Electrical Insulation, 2006
- Electrode conditioning characteristics in vacuum under impulse voltage application in non-uniform electric fieldIEEE Transactions on Dielectrics and Electrical Insulation, 2005