Effect of Oil Mist on Tool Temperature in Cutting
- 1 February 2005
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 128 (1) , 130-135
Abstract
In this paper, the influence of oil mist on the tool temperature in cutting is investigated experimentally. The turning of a carbon steel with oil mist applied is performed, and the temperature of the alumina tool at the tool-chip interface is measured using a two-color pyrometer. The tool temperature in dry cutting at a cutting speed of 300 m/min is , but it is when oil mist is supplied. In intermittent turning, the oil mist has more effect on the tool temperature because it is supplied more efficiently to the tool-chip interface. In end milling with the oil mist applied, the tool temperature at the flank face is at a cutting speed of 400 m/min, though in dry cutting it is .
Keywords
This publication has 8 references indexed in Scilit:
- Investigation of Temperature at Tool-Chip Interface in Turning Using Two-Color PyrometerJournal of Manufacturing Science and Engineering, 2002
- Thermal Stress Cleaving of Brittle Materials by Laser BeamCIRP Annals, 2002
- Temperature on Flank Face of Cutting Tool in High Speed MillingCIRP Annals, 2001
- The Temperature of a Single Crystal Diamond Tool in TurningCIRP Annals, 1998
- Dry CuttingCIRP Annals, 1997
- Thermal Behaviour of Cutting Grain in GrindingCIRP Annals, 1995
- Energy Partition to the Workpiece for Grinding of CeramicsCIRP Annals, 1995
- Studies on Temperature of Abrasive Grains in Grinding—Application of Infrared Radiation PyrometerJournal of Engineering for Industry, 1985