Wear of nanofilled dental composites at varying filler concentrations
- 7 June 2014
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 103 (2) , 424-429
Abstract
The aim of this study is to examine the effects of nanofiller concentration on the mechanisms of wear of a dental composite. Nanofilled composites were fabricated with a bisphenol A glycidyl methacrylate polymer and 40 nm SiO2 filler particles at three filler loads (25, 50, and 65 wt %). The elastic modulus, flexural strength, and hardness of the composites and the unfilled resin were measured. The materials (n = 8) were tested in the modified wear testing device at 50,000, 100,000, and 200,000 cycles with 20N force at 1 Hz. A 33% glycerine lubricant and stainless steel antagonist were used. The worn composite and antagonist surfaces were analyzed with noncontact profilometry and SEM. The volumetric wear data indicated that there are significant differences between filler concentrations and cycles (p < 0.05). A trend was noted that increasing filler content beyond 25% decreased the wear resistance of the composites. Increasing filler content increased hardness and modulus and increased flexural strength up to 50% fill. SEM evaluation of the worn specimens indicated that the resin and 25% filled materials exhibited cracking and failed by fatigue and the 50 and 65% filled materials exhibited microcutting and failed by abrasive wear. Based on the results of this study, composite manufacturers are recommended to use a filler concentration between 25 and 50% when using nanosized filler particles. © 2014 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 103B: 424–429, 2015.Keywords
Funding Information
- National Institute of Dental and Craniofacial Research (T-32 DE017607)
This publication has 26 references indexed in Scilit:
- Nanofilled and microhybrid composite restorations: Five-year clinical wear performancesDental Materials, 2011
- Resin composite—State of the artDental Materials, 2011
- Investigation of Mechanical Properties of Experimental Bis-GMA/TEGDMA Dental Composite Resins Containing Various Mass Fractions of Silica NanoparticlesJournal of Prosthodontics, 2010
- Evaluation of the surface hardness of composite resins before and after polishing at different timesJournal of Applied Oral Science, 2006
- Two-year clinical performance of a nanofiller vs a fine-particle hybrid resin compositeClinical Oral Investigations, 2006
- Nanoindentation of dental compositesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Effect of filler fraction and filler surface treatment on wear of microfilled compositesDental Materials, 2002
- Wear characteristics in a two-body wear testDental Materials, 1994
- Materials Science Effect of Filler Content and Size on Properties of CompositesJournal of Dental Research, 1985
- Comparative in vitro Sliding-wear Study of Conventional, Microfilled, and Light-cured Composite RestorativesJournal of Dental Research, 1984