Development of Alternative Thermal Barrier Coatings for Diesel Engines
Authors:
- 11 April 2005
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The use of thermal barrier coatings (TBCs) to increase the combustion temperature in diesel engines has been pursued for over 20 years. Increased combustion temperature can increase the efficiency of the engine, decrease the CO and (possibly) the NOx emission rate. However, TBCs have not yet met with wide success in diesel engine applications. The most common TBC system is Yttria Partially Stabilized Zirconia (Y-PSZ) which has shown good performance in turbine blade coatings where temperatures approach 1100°C. To reach the desirable temperature of 850-900°C in the combustion chamber from the current temperature of 350-400°C, a coating with a thickness of order 1mm is required, significantly thicker than turbine blade coatings which are on the order of 100μm thick. This results in different temperature and stress profiles in the coating during service than in the case of turbine coatings, and different failure mechanisms. Recent advances in the control of coating structure have led to the development of new PSZ coating microstructures containing grains and pores with sizes in the range of 100-300 nm. Thermal-mechanical properties of such coatings have been characterized and compared with coatings exhibiting the traditional thermal spray structure to asses their suitability as thick TBC for diesel engine applications. Selected coatings have been subjected to engine testing in an instrumented single cylinder diesel test rig. Among possible alternative materials, one of the most promising is mullite. Mullite has excellent thermo-mechanical behavior; however its low coefficient of thermal expansion creates a large mismatch with the substrate. To address this problem, multilayer systems have been developed which minimize the thermal expansion mismatch stresses while maintaining chemical and phase stability. The design considerations for such multilayer systems are discussed.Keywords
This publication has 25 references indexed in Scilit:
- Ceramic materials for thermal barrier coatingsJournal of the European Ceramic Society, 2004
- Interface thermal fracture in functionally graded zirconia–mullite–bond coat alloy thermal barrier coatingsActa Materialia, 2003
- The effect of thermal barrier coatings on diesel engine performanceVacuum, 2002
- The dependency of microstructure and properties of nanostructured coatings on plasma spray conditionsSurface and Coatings Technology, 2000
- Thermomechanical fatigue characterization of zirconia (8%Y2O3-ZrO2) and mullite thermal barrier coatings on diesel engine components: Effect of coatings on engine performanceProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2000
- Directions of the development of thermal barrier coatings in energy applicationsJournal of Materials Processing Technology, 1999
- Thermal Barrier Coatings For Low Emission, High Efficiency Diesel Engine ApplicationsSAE International Journal of Advances and Current Practices in Mobility, 1999
- Effects of thermal gradient and residual stresses on thermal barrier coating fractureMechanics of Materials, 1998
- Surface thermal cracking of thermal barrier coatings owing to stress relaxation: zirconia vs. mulliteSurface and Coatings Technology, 1996
- The potential for nanostructured materials in gas turbine enginesNanostructured Materials, 1995