A Pure Pulse Voltage-Based Method for Broadband Impedance Spectrum Measurement of Cables
- 18 June 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-8
Abstract
The application of broadband impedance spectrum has become a high-performance method for localizing minor defects within cables. The primary focus of broadband impedance spectrum research has been on improving algorithms for analyzing the spectrum, with less attention given to its acquisition. Broadband impedance spectrum is typically obtained using frequency-sweeping impedance analyzers or vector network analyzers, which are often costly. In contrast to frequency-sweeping acquisition methods, this paper proposes a cost-effective, pulse voltage-based method to acquire the broadband impedance spectrum of cables by relying exclusively on measuring time-domain pulse voltages, without measuring current, under two configurations: with the cable connected to the acquisition system and with it disconnected. To enhance its applicability in practical scenarios, two correction methods are proposed to mitigate the influence of both external extension cables and internal connection cables. The experimental results demonstrate that the proposed method reliably acquires broadband impedance spectrum of cables, with a normalized root mean square error of less than 3% compared to the results obtained by impedance analyzer.Keywords
This publication has 19 references indexed in Scilit:
- Recent Advancements in Optical Frequency-Domain Reflectometry: A ReviewIEEE Sensors Journal, 2022
- Effect of Segmented Thermal Aging on Defect Location Accuracy in XLPE Distribution CablesIEEE Access, 2021
- The Possibility of Fault Location in Cross-Bonded Cables by Broadband Impedance SpectroscopyIEEE Transactions on Dielectrics and Electrical Insulation, 2021
- Natural Amplification of Soft Defects Signatures in Cables Using Binary Time Domain ReflectometryIEEE Sensors Journal, 2019
- Monitoring Method for an Unbalanced Three-Phase HTS Cable System via Time-Frequency Domain ReflectometryIEEE Transactions on Applied Superconductivity, 2018
- Review of recent research towards power cable life cycle managementHigh Voltage, 2017
- Local degradation diagnosis for cable insulation based on broadband impedance spectroscopyIEEE Transactions on Dielectrics and Electrical Insulation, 2015
- Precise location of the excessive temperature points in polymer insulated cablesIEEE Transactions on Dielectrics and Electrical Insulation, 2013
- A New Algorithm for Wire Fault Location Using Time-Domain ReflectometryIEEE Sensors Journal, 2013
- Location feasibility of degradation in cable through Fourier transform analysis of broadband impedance spectraElectrical Engineering in Japan, 2013