Compressive and tensile properties of polyurethane foam mimicking trabecular tissue in artificial femoral head bones
Open Access
- 17 January 2025
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Bioengineering and Biotechnology
- Vol. 12, 1482165
Abstract
Introduction: Most orthopedic implants for fracture fixation and joint replacement are commonly tested on artificial bones. Polyurethane foam is one of the most frequently used synthetic bone materials for mimicking human trabecular tissue. The study aimed to examine the compressive and tensile behavior of polyurethane foams mimicking trabecular tissue in artificial human femurs and assess their potential to replicate the osteoporotic type of human bone tissue.Materials and methods: Two types of SYNBONE femur models, one of normal density (model 2350) and one of lower density (model LD2350), and three types of Sawbones femur models (models 1130-21-8, 1130-21-3, and 1130-192) were investigated. Polyurethane foams were extracted as slices cut in the coronal plane from the femoral head. Cuboid samples were cut in three directions and uniaxial tested to identify compressive and tensile properties, including elastic modulus, Poisson’s ratio, yield limit, and ultimate strength.Results: The ANOVA test revealed that only SYNBONE LD2350 trabecular tissue exhibits anisotropy properties (p < 0.001). In most cases, the tensile properties were greater than compressive ones (t-test, p < 0.001).Conclusion: The obtained results are within the ranges suggested by other authors for mimicking osteoporotic human tissue. The presented data broadens the range of data on mechanical properties provided by the producers. These data can serve as a reference for research using composite femurs made of these particular polyurethane foams for conducting biomechanical studies and validating accompanying numerical simulations.Keywords
This publication has 36 references indexed in Scilit:
- The early failure of the gamma nail and the dynamic hip screw in femurs with a wide medullary canal. A biomechanical study of intertrochanteric fracturesClinical Biomechanics, 2020
- Individual synthetic head models in wound ballistics — A feasibility study based on real casesForensic Science International, 2019
- Investigation of the high-strain rate (shock and ballistic) response of the elastomeric tissue simulant Perma-Gel®International Journal of Impact Engineering, 2016
- Validated finite element models of the proximal femur using two-dimensional projected geometry and bone densityComputer Methods and Programs in Biomedicine, 2011
- Characterization of commercial rigid polyurethane foams used as bone analogs for implant testingJournal of Materials Science: Materials in Medicine, 2010
- Structural Properties of a Novel Design of Composite Analogue Humeri ModelsAnnals of Biomedical Engineering, 2008
- Difference in femoral head and neck material properties between osteoarthritis and osteoporosisClinical Biomechanics, 2008
- Characterization of three formulations of a synthetic foam as models for a range of human cancellous bone typesJournal of Applied Biomaterials, 1995
- Technical note. Characterization of a synthetic foam as a model for human cancellous boneJournal of Applied Biomaterials, 1993
- The mechanical characteristics of cancellous bone at the upper femoral regionJournal of Biomechanics, 1983