Frequency Shift in Drilling due to Margin Engagement
Authors:
- 25 April 2005
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 127 (2) , 271-276
Abstract
Drill chatter degrades hole roundness, hole size, and tool life. This wastes time and money in tools, scrap, and hole rework. Chatter prediction in milling and turning has shown significant benefit to industry; however, researchers have been unable to accurately predict chatter in drilling applications. In the past, the drill, including the chisel edge, was modeled as either a fixed-fixed or fixed-pinned beam (Tekinalp, O., and Ulsoy, A. G., 1989, “Modeling and Finite Element Analysis of Drill Bit Vibrations,” ASME J. Eng. Indust. 111, pp. 148–154), but more recent research (Dilley, D. N., Bayly, P. V., and Schaut, A. J., 2005, “Effects of the Chisel Edge on the Chatter Frequency in Drilling,” J. Sound Vib., 281, pp. 423–428) has shown that a fixed-embedded model using springs improves frequency matching. The effects of the drill margins on dynamics have not been studied. The fixed-fixed or fixed-pinned model will be shown to be inappropriate for modeling the effects of margin engagement, while the spring-end boundary condition can better approximate the frequency increase observed experimentally as the drill margins engage deeper into the hole. In addition, the shifted frequency is well below the frequency found from an analytical fixed-fixed or fixed-pinned beam. Evidence that the margins cause the frequency shift is seen in three-dimensional waterfall plots that show this shift for pilot hole drilling (in which the margins are engaged), but not for tube drilling (in which margins are not engaged).Keywords
This publication has 15 references indexed in Scilit:
- Effects of the chisel edge on the chatter frequency in drillingJournal of Sound and Vibration, 2005
- Low-Frequency Regenerative Vibration and the Formation of Lobed Holes in DrillingJournal of Manufacturing Science and Engineering, 2002
- Modelling and simulation of high‐speed machiningInternational Journal for Numerical Methods in Engineering, 1995
- Analytical Prediction of Stability Lobes in MillingCIRP Annals, 1995
- A New Theoretical Approach for the Prediction of Machine Tool Chatter in MillingJournal of Engineering for Industry, 1993
- Calculation of main cutting edge forces and torque for drills with arbitrary point geometriesInternational Journal of Machine Tools and Manufacture, 1992
- Effects of Geometric and Process Parameters on Drill Transverse VibrationsJournal of Engineering for Industry, 1990
- Modeling and Finite Element Analysis of Drill Bit VibrationsJournal of Vibration and Acoustics, 1989
- Whirling Vibration in Drilling. Part 3: Vibration Analysis in Drilling Workpiece with a Pilot HoleJournal of Engineering for Industry, 1988
- An Analysis of the Drill Wandering MotionJournal of Engineering for Industry, 1987