Optimisation of Imaging Confocal Microscopy for Topography Measurements of Metal Additive Surfaces
Open Access
Abstract
Additive manufactured surfaces, especially metal powder bed fusion surfaces, present unique challenges for measurement because of their complex topographies. To address these measurement challenges, optimisation of the measurement process is required. Using a statistical approach, sensitivity analyses were performed on measurement settings found on a commercial programmable array scanning confocal microscope. The instrument measurement process parameters were compared by their effects on three quality indicators: the areal surface texture parameter Sa, measurement noise, and number of non-measured points. An analysis was performed using a full factorial design of experiments for both the top and side surfaces of test surfaces made from Inconel 718 and Ti-6Al-4V using powder bed fusion. The results indicated that measurements of metal additive surfaces are robust to changes in the measurement control parameters for Sa, with variations within 5% of the mean parameter value for the same objective, surface, and measured area. The number of non-measured points and the measurement noise were more varied and were affected by the choice of measurement control parameters, but such changes could be predicted by the statistical models. The contribution offered by this work is an increased understanding of imaging confocal microscopy measurement of metal additive surfaces, along with the establishment of good practice guidance for measurements.Keywords
Funding Information
- “PAM2 (Precision Additive Metal Manufacturing)” of the EU Framework Programme for Research and Innovation within Horizon 2020—Marie Skłodowska-Curie Innovative Training Networks (721383, EP/L01534X/1, EP/M008983/1)
- Engineering and Physical Sciences Research Council (721383, EP/L01534X/1, EP/M008983/1)
- Manufacturing Technology Centre (Coventry, UK) (721383, EP/L01534X/1, EP/M008983/1)
This publication has 25 references indexed in Scilit:
- Characterisation of the topography of metal additive surface features with different measurement technologiesMeasurement Science and Technology, 2017
- Optimization of surface measurement for metal additive manufacturing using coherence scanning interferometryOptical Engineering, 2017
- The Meaning and Measure of Vertical Resolution in Optical Surface Topography MeasurementApplied Sciences, 2017
- Topography of selectively laser melted surfaces: A comparison of different measurement methodsCIRP Annals, 2017
- Surface texture metrology for metal additive manufacturing: a reviewPrecision Engineering, 2016
- Three-dimensional measurements with a novel technique combination of confocal and focus variation with a simultaneous scan2016
- Uncertainty in measurement of surface topographySurface Topography: Metrology and Properties, 2015
- Characterization of typical surface effects in additive manufacturing with confocal microscopySurface Topography: Metrology and Properties, 2015
- Calibration of the scales of areal surface topography-measuring instruments: part 1. Measurement noise and residual flatnessMeasurement Science and Technology, 2012
- Analysis of variance (ANOVA)Chemometrics and Intelligent Laboratory Systems, 1989