Multi-Parameter Optimization of Stator Coreless Disc Motor Based on Orthogonal Response Surface Method
Open Access
- 10 July 2023
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 12 (14) , 3020
Abstract
In response to the structural optimization problem of PCB stator coreless disc motors, the orthogonal response surface method was used to optimize the motor structure, preliminarily determine the basic parameters of the motor, and conduct orthogonal experiments on the motor parameters based on the optimization design objectives. The optimization factors were the quantity of the magnetic pole of the motor rotor p, the ratio of the main/auxiliary pole sizes Rnd, the thickness Tm of the permanent magnet, and the air gap length δ. The motor torque Td, the amplitude of the magnetic density of the air gap Bδ, and the waveform distortion rate THD were used as optimization objectives. The motor parameters that cause the motor torque to reach a maximum cause the air gap magnetic density to reach a maximum and the waveform distortion rate to reach a minimum. Due to the use of PCB plates instead of motor stator cores in the PCB coreless disc motors, the service life of the PCB board during motor operation will be reduced with the temperature increase generated by the stator winding. To solve this problem, a response surface analysis of the motor was carried out to reduce the increase in the temperature of the stator windings during the operation of the motor. The PCB board and stator winding are the main factors affecting the motor’s temperature increase. Taking the thickness of the PCB board, the hole diameter on the board, and the uneven width of the stator winding as optimization factors, the motor parameters with the lowest increase in the temperature of the motor winding were obtained. A simulation analysis was conducted using Ansys/Maxwell software, and the results prove the feasibility of the optimization.Keywords
All Related Versions
Funding Information
- S&T Program of Hebei (20314501D, ZD2022030)
- Technology Project of Hebei Education Department (20314501D, ZD2022030)
- Overseas Expertise Introduction Project of Hebei (20314501D, ZD2022030)
This publication has 10 references indexed in Scilit:
- Robust Predictive Control Scheme for Permanent-Magnet Synchronous Generators Based Modern Wind TurbinesElectronics, 2021
- Design and Modeling of a Robust Sensorless Control System for a Linear Permanent Magnet Synchronous MotorElectronics, 2021
- Research on a Novel Transverse Flux Permanent Magnet Motor With Hybrid Stator Core and Disk-Type Rotor for Industrial Robot ApplicationsIEEE Transactions on Industrial Electronics, 2020
- On Phase Shifting and Diversified Coil-Pitch for Enhanced Multiobjective Winding Design OptimizationIEEE Transactions on Energy Conversion, 2020
- Multi-objective Optimization Design of Variable-Saliency-Ratio PM Motor Considering Driving CyclesIEEE Transactions on Industrial Electronics, 2020
- Multiobjective Deterministic and Robust Optimization Design of a New Spoke-Type Permanent Magnet Machine for the Improvement of Torque PerformanceIEEE Transactions on Industrial Electronics, 2020
- Multi-Objective Optimization of a Direct-Drive Dual-Structure Permanent Magnet MachineIEEE Transactions on Magnetics, 2019
- Electromagnetic Force and Vibration Analysis of Permanent-Magnet-Assisted Synchronous Reluctance MachinesIEEE Transactions on Industry Applications, 2018
- Application of Particle Swarm Optimization Combined With Response Surface Methodology to Transverse Flux Permanent Magnet Motor OptimizationIEEE Transactions on Magnetics, 2017
- Maximum power point tracking of a variable speed wind turbine with a coreless AFPM synchronous generator using OTC method2017