Transformer-Based Predistortion Linearizer for High Linearity and High Modulation Efficiency in mm-Wave 5G CMOS Power Amplifiers
- 27 May 2019
- journal article
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 67 (7) , 3074-3087
Abstract
This paper presents a new predistortion linearization technique for high linearity and high modulation efficiency in millimeter-wave (mm-wave) CMOS power amplifiers (PA) for fifth-generation (5G) mobile communications. Our proposed linearizer adopts a transformer-based (i.e., inductive) self-compensated predistortion network at the input of the PA whose amplitude-modulation to phase-modulation (AM-PM) response is opposite compared with the AM-PM response of a CMOS PA, resulting in an AM-PM cancellation effect. This proposed inductive linearization method mitigates the large gain reduction problem in traditional capacitor-based linearization approaches while consuming no extra dc power or without introducing additional control circuitry. As a result, a significant improvement in power-efficiency and linearity is achieved with high-order complex modulation signals. To validate the proposed linearization method, a PA prototype in 65-nm CMOS technology was fabricated and tested, and it exhibited <1° of | AM-PM| distortion at Pₒ,1, dB over 4 GHz of bandwidth (27-31 GHz). At 28 GHz, the measured saturated Pₒ and peak power-added-efficiency (PAE) was 15.6 dBm and 41%, respectively, while achieving a 6-dB Pₒ back-off PAE of 25%. To assess PA's large-signal performance for 5G communications, the prototype was measured with the 64-quadratic-amplitude modulation (QAM) signal at 2-Gb/s data rates at 28 and 30 GHz, and the PA achieves modulated-PAE of 18.2%/17.6% and average-Pₒ of 9.8 dBm/10 dBm, respectively, while maintaining <-30 dBc of adjacent-channel-power-ratio and <-25.5 dB of error-vector-magnitude. The achieved modulated-PAE at 28 and 30 GHz shows more than 2x improvement in comparison with the recently reported 28-GHz linear CMOS PAs. Also, the PA occupies a compact active-area of 0.24 mm².Keywords
Funding Information
- National Science Foundation (CNS-1564014, CNS-1705026)
- Center for Design of Analog–Digital Integrated Circuits
- Joint Center for Aerospace Technology Innovation
This publication has 38 references indexed in Scilit:
- Multi-Band Complexity-Reduced Generalized-Memory-Polynomial Power-Amplifier Digital PredistortionIEEE Transactions on Microwave Theory and Techniques, 2016
- High-Efficiency E-Band Power Amplifiers and Transmitter Using Gate Capacitance Linearization in a 65-nm CMOS ProcessIEEE Transactions on Circuits and Systems II: Express Briefs, 2016
- A 28-GHz inverse class-F power amplifier with coupled-inductor based harmonic impedance modulator2015
- MMW Ultra-Compact ${\rm N}$-Way Transformer PAs Using Bowtie-Radial Architecture in 65-nm CMOSIEEE Microwave and Wireless Components Letters, 2015
- Performance Limits, Design and Implementation of mm-Wave SiGe HBT Class-E and Stacked Class-E Power AmplifiersIEEE Journal of Solid-State Circuits, 2014
- A 60 GHz Drain-Source Neutralized Wideband Linear Power Amplifier in 28 nm CMOSIEEE Transactions on Circuits and Systems I: Regular Papers, 2014
- High-Power High-Efficiency Class-E-Like Stacked mmWave PAs in SOI and Bulk CMOS: Theory and ImplementationIEEE Transactions on Microwave Theory and Techniques, 2014
- Broadband CMOS stacked power amplifier using reconfigurable interstage network for envelope tracking application2014
- A 5-GHz 20-dBm Power Amplifier With Digitally Assisted AM-PM Correction in a 90-nm CMOS ProcessIEEE Journal of Solid-State Circuits, 2006
- An L-band high-efficiency and low-distortion power amplifier using HPF/LPF combined interstage matching circuitIEEE Transactions on Microwave Theory and Techniques, 2000