Investigation of the effect of coating on hydrogen charge and thermal characteristics in LaNi5 based metal hydrides
- 29 December 2025
- journal article
- Published by Türkiye Enerji Stratejileri ve Politikalari Araştirma Merkezi (TESPAM) in International Journal of Energy Studies
- Vol. 10 (4) , 1447-1459
Abstract
The thermal and mass behavior of LaNi5 alloy, a metal hydride-based hydrogen storage material, modified with different surface coating types was investigated during the hydrogen storage process. Based on the experimentally measured thermal conductivity coefficients, four different sample groups were created: Sample 1 – uncoated LaNi5 powder, Sample 2 – copper-coated LaNi5, Sample 3 – copper/silver double-layer-coated LaNi5, and Sample 4 – silver-coated LaNi5. The thermal conductivity values of each sample were determined, and these data were evaluated in a three-dimensional model developed in COMSOL Multiphysics software. During the modeling process, the amount of hydrogen stored in the metal hydride reactor under different operating pressures (4 bar, 8 bar, and 12 bar) was calculated; the transient temperature distribution and hydrogen concentration profiles of the system were analyzed with time. It was shown that the coated samples – especially the Cu, Cu/Ag, and Ag coated samples – had higher thermal conductivities than the uncoated sample. This increase contributes to the shortening of the hydrogen absorption time and the limitation of local temperature increases, resulting in a more homogeneous temperature distribution in the system.Keywords
This publication has 10 references indexed in Scilit:
- 2D-axisymmetrical modeling and experimental study of hydrogen absorption in copper coated metal hydrideInternational Journal of Hydrogen Energy, 2023
- Upscaling of LaNi5-based metal hydride reactor for solid-state hydrogen storage2023
- The effect of copper coated metal hydride at different ratios on the reaction kineticsInternational Journal of Hydrogen Energy, 2022
- Thermodynamic analysis of a metal hydride hydrogen compressor with aluminium substituted LaNi5 hydridesInternational Journal of Hydrogen Energy, 2022
- Enhancement of electrical and thermal conductivity of low-cost novel Cu–Ag alloys prepared by hot-pressing and electroless plating from recycled electrolytic copper powdersMaterials Chemistry and Physics, 2022
- Thermofluidynamic modelling of hydrogen absorption in metal hydride beds by using multiphysics softwareInternational Journal of Hydrogen Energy, 2020
- Enhancement of hydrogen charging in metal hydride-based storage systems using heat pipeInternational Journal of Hydrogen Energy, 2019
- Fabrication and microstructure of W-Cu composites prepared from Ag-coated Cu powders by electroless platingSurface and Coatings Technology, 2019
- Thermal conductivity measurements of copper-coated metal hydrides (LaNi5, Ca0.6Mm0.4Ni5, and LaNi4.75Al0.25) for use in metal hydride hydrogen compression systemsInternational Journal of Hydrogen Energy, 2009
- Numerical investigation of heat and mass transfer in a metal hydride bedApplied Mathematics and Computation, 2004