Intra- and inter-operator reliability of three-dimensional preoperative planning in total knee arthroplasty
Open Access
- 15 July 2024
- journal article
- research article
- Published by Springer Nature in Archives of orthopaedic and trauma surgery
- Vol. 144 (8) , 3625-3630
Abstract
Purpose: To characterize the intra- and inter-operator reliability of a CT-based 3D preoperative planning software. Materials and methods: This study analyzed 30 CT scans of de-identified knees with osteoarthritis. For each scan, a case planner segmented the bones and pre-planned the TKA. Three orthopedic surgeons then reviewed each pre-planning three times at least one week apart, in a blinded manner. During the reviews, the surgeons modified the pre-plannings until they felt the plannings matched the objectives defined collegially at the beginning of the study. Reliability was assessed using the Intraclass Correlation Coefficient (ICC) and the Standard Error of Measurement (SEM). Results: The intra- and inter-operator reliabilities for implant size selection were almost perfect (ICC between 0.97 and 0.99). Implants of same sizes were selected in 67.1–90.0% of cases. For implant placements, almost perfect intra- and inter-operator reliability was observed in all degrees-of-freedom (ICC between 0.81 and 1.00), except in flexion-extension for the femur (intra-operator ICC between: 0.76 and 0.99; inter-operator ICC of 0.61) and the tibia (intra-operator ICC between 0.12 and 1.00; inter-operator ICC of 0.03). All implant placements SEM were below 1.3 mm or 1.7°. Conclusions: This study showed high intra- and inter-operator reliability for implant size selection and, in most of the degrees-of-freedom, also for implant placements. Further research is needed to evaluate the benefit of developing more precise means of describing the objectives of the surgical planning as well as to evaluate the possibility and relevance of adding features in the planning software to assist the operators.Keywords
Funding Information
- University of Lausanne
This publication has 23 references indexed in Scilit:
- High intra‐ and inter‐observer reliability of planning implant size in MRI‐based patient‐specific instrumentation for total knee arthroplastyKnee Surgery, Sports Traumatology, Arthroscopy, 2020
- Medial Overhang of the Tibial Component Is Associated With Higher Risk of Inferior Knee Injury and Osteoarthritis Outcome Score Pain After Knee ReplacementThe Journal of Arthroplasty, 2018
- Patient-specific instruments for total knee arthroplasty can accurately predict the component size as used peroperativeKnee Surgery, Sports Traumatology, Arthroscopy, 2016
- Robotics in Arthroplasty: A Comprehensive ReviewThe Journal of Arthroplasty, 2016
- Template-Directed Instrumentation Reduces Cost and Improves Efficiency for Total Knee Arthroplasty: An Economic Decision Analysis and Pilot StudyThe Journal of Arthroplasty, 2015
- Oversizing the tibial component in TKAs: incidence, consequences and risk factorsKnee Surgery, Sports Traumatology, Arthroscopy, 2015
- Mediolateral oversizing influences pain, function, and flexion after TKAKnee Surgery, Sports Traumatology, Arthroscopy, 2013
- Patient Satisfaction after Total Knee Arthroplasty: Who is Satisfied and Who is Not?Clinical Orthopaedics and Related Research, 2010
- Implant Migration and Failure in Total Knee Arthroplasty is Related to Body Mass Index and Tibial Component SizeThe Journal of Arthroplasty, 2008
- Sample size and optimal designs for reliability studiesStatistics in Medicine, 1998