Nafion∕TiO[sub 2] Proton Conductive Composite Membranes for PEMFCs Operating at Elevated Temperature and Reduced Relative Humidity
Authors:
Open Access
- 1 January 2005
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 152 (6) , A1035-A1040
Abstract
Nafion∕TiO2Nafion∕TiO2 composite membranes with different TiO2TiO2 contents were studied in an H2∕O2H2∕O2 proton exchange membrane fuel cell (PEMFC) over a wide range of relative humidity (RH) values from 26 to 100% at temperatures of 80 and 120°C. The composite membranes, which were prepared using a recast procedure, showed a pronounced improvement over unmodified Nafion membranes when operated at 120°C and reduced RH. For instance, at 50% RH, the Nafion/20% TiO2TiO2 membrane demonstrated a performance identical to that of an unmodified Nafion membrane operated at 100% RH. This performance level was comparable to that of a bare Nafion membrane at 80°C. The high performance of the Nafion∕TiO2Nafion∕TiO2 composite membranes at low RH was attributed to improved water retention due to the presence of absorbed water species in the electrical double layer on the TiO2TiO2 surface. The zeta potential and thickness of the hydrodynamically immobile water layer at the TiO2∕waterTiO2∕water interface were discussed as parameters influencing the water balance in the membranes. The obtained experimental PEMFC performance data were fitted using an analytical equation, and calculated parameters were analyzed as functions of RH and TiO2TiO2 content in the composite membranes.Keywords
This publication has 20 references indexed in Scilit:
- Nafion-Teflon-Zr(HPO[sub 4])[sub 2] Composite Membranes for High-Temperature PEMFCsJournal of the Electrochemical Society, 2004
- Influence of the acid–base characteristics of inorganic fillers on the high temperature performance of composite membranes in direct methanol fuel cellsSolid State Ionics, 2003
- Zetameter for microelectrophoresis studies of the oxide/water interface at temperatures up to 200 °CReview of Scientific Instruments, 2003
- Nafion® 115/zirconium phosphate composite membranes for operation of PEMFCs above 100°CElectrochimica Acta, 2002
- Silicon Oxide Nafion Composite Membranes for Proton-Exchange Membrane Fuel Cell Operation at 80-140°CJournal of the Electrochemical Society, 2002
- Suppression of Methanol Crossover and Distribution of Ohmic Resistance in Pt-Dispersed PEMs under DMFC OperationJournal of the Electrochemical Society, 2002
- On the development of proton conducting polymer membranes for hydrogen and methanol fuel cellsJournal of Membrane Science, 2001
- Composite Nafion/Zirconium Phosphate Membranes for Direct Methanol Fuel Cell Operation at High TemperatureElectrochemical and Solid-State Letters, 2001
- Investigation of a direct methanol fuel cell based on a composite Nafion®-silica electrolyte for high temperature operationSolid State Ionics, 1999
- Comparison of Ethanol and Methanol Oxidation in a Liquid-Feed Solid Polymer Electrolyte Fuel Cell at High TemperatureElectrochemical and Solid-State Letters, 1999