Hybrid Mortar Composites Incorporating Oyster Shell Filler and Recycled Fibers from Disposable Masks
Authors:
- René Sebastián Mora-OrtizRené Sebastián Mora-Ortiz
- Sergio Alberto Díaz AlvaradoSASergio Alberto Díaz Alvarado
- Ebelia Del Angel-MerazEAEbelia Del Angel-Meraz
- Francisco Magaña-HernándezFMFrancisco Magaña-Hernández
- Mayra Agustina Pantoja CastroMCMayra Agustina Pantoja Castro
- Emmanuel Munguía-BalvaneraEMEmmanuel Munguía-Balvanera
Open Access
Abstract
This study presents the development of hybrid masonry mortars by incorporating two waste materials: recycled plastic strips from disposable face masks (FM) as mechanical reinforcement and calcined oyster shell powder (OSP) as a filler. The objective was to evaluate the combined effect of FM and OSP on the mechanical behavior of mortars. Three types of mixes were prepared: a reference mix, a mix with 5% OSP (by cement weight), and mixes with 5% OSP reinforced with FM strips. FM strips were incorporated at three different lengths, dividing the FM-reinforced group into three subgroups (0.1%, 0.2%, 0.5%, and 0.8%). The results showed an approximately 10% increase in compressive strength with the addition of 5% OSP compared to the control mortar, as well as an improvement in bond strength of about 21%. Furthermore, an optimum content of 0.2% of 6 mm strips allowed for adequate dispersion and maintained indirect tensile strengths similar to the control + OSP. OSP acted as a reactive filler, increasing compressive strength and improving both density and adhesion. However, higher FM contents or longer strips increased porosity and water absorption, while reducing strength. This combination represents an innovative strategy for valorizing post-pandemic and marine waste.Keywords
This publication has 86 references indexed in Scilit:
- Effect of temperature on binding process of calcium carbonate concrete through aragonite crystals precipitationComposites Part B: Engineering, 2024
- Utilization of face masks and ladle furnace slag in concrete: Insights from experimental studyCleaner Engineering and Technology, 2023
- Using Fibre recovered from face mask waste to improve printability in 3D concrete printingCement and Concrete Composites, 2023
- Valorisation of face mask waste in mortarInnovative Infrastructure Solutions, 2021
- Recycling/reuse of plastic waste as construction material for sustainable development: a reviewEnvironmental Science and Pollution Research, 2021
- Decontamination of surgical face masks and N95 respirators by dry heat pasteurization for one hour at 70°CAmerican Journal of Infection Control, 2020
- Experimental Study on Mechanical and Durability Properties of Glass and Polypropylene Fiber Reinforced ConcreteFibers and Polymers, 2019
- Effect of different types of fibers on the microstructure and the mechanical behavior of Ultra-High Performance Fiber-Reinforced ConcretesComposites Part B: Engineering, 2016
- Use of limestone obtained from waste of the mussel cannery industry for the production of mortarsCement and Concrete Research, 2007
- Strength properties of nylon- and polypropylene-fiber-reinforced concretesCement and Concrete Research, 2005