Comparative Study of Glass Fiber Content Measurement Methods for Inspecting Fabrication Quality of Composite Ship Structures
Open Access
- 26 July 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (15) , 5130
Abstract
A comparative study of glass fiber content (Gc) measurement methods was conducted using actual glass fiber reinforced plastic laminates from the hull plate of a 26-ton yacht. Two prototype side hull plates with the design Gc (40 wt.%) and higher Gc (64 wt.%) were prepared. Four methods were used to study the samples: the calculation method suggested by classification societies’ rules; two direct measurement methods using either calipers and scales or a hydrometer; and the burn-off method, wherein the resin matrix is combusted from the laminates. The results were compared and analyzed to identify the accuracy and benefits of each method. The rule calculation method was found to be effective if the quality of the manufacturing process is known. However, fabrication errors in the laminate structures cannot be detected. Additionally, while direct methods are used to measure the density of glass fibers using measurements of the densities of raw materials and laminates, the volume of inner defects occurring during the fabrication of laminates could not be considered. Finally, it was found that the burn-off method measures Gc and considers the defect volume (voids) inside laminates as well as the non-uniformity of the external shape.Keywords
Funding Information
- Basic Science Research Program through the National Research Foundation of Korea (NRF), funded by the Ministry of Education (NRF-2017R1D1A3B03032051)
- IoT and AI based development of Digital Twin for Block Assembly Process Program of the Korean Ministry of Trade, Industry and Energy, Republic of Korea (20006978)
This publication has 13 references indexed in Scilit:
- Comparative analysis of failure detection methods of composites materials’ systemsSystems Science & Control Engineering, 2017
- Comparison of four methods for determining fiber content of carbon fiber/epoxy compositesInternational Journal of Polymer Analysis and Characterization, 2016
- Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement2015
- Test Methods for Constituent Content of Composite Materials2015
- Mechanical properties and production quality of hand-layup and vacuum infusion processed hybrid composite materials for GFRP marine structuresInternational Journal of Naval Architecture and Ocean Engineering, 2014
- Effects of vacuum pressure, inlet pressure, and mold temperature on the void content, volume fraction of polyester/e-glass fiber composites manufactured with VARTM processJournal of Composite Materials, 2011
- Recycling technologies for thermoset composite materials—current statusComposites Part A: Applied Science and Manufacturing, 2006
- Composite recycling in the construction industryComposites Part A: Applied Science and Manufacturing, 2006
- A Test Method to Determine the Fiber and Void Contents of Carbon/Glass Hybrid CompositesJournal of ASTM International, 2004
- Non-destructive detection of fatigue damage in thick composites by pulse-echo ultrasonicsComposites Science and Technology, 2000