Chemically Deposited CdS Buffer/Kesterite Cu2ZnSnS4 Solar Cells: Relationship between CdS Thickness and Device Performance
- 16 October 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (42) , 36733-36744
Abstract
: Earth-abundant, copper-zinc-tin-sulfide (CZTS) kesterite, is an attractive absorber material for thin-film solar cells (TFSCs). However, the open circuit voltage deficit (Voc-deficit) resulting from high recombination rate at buffer/absorber interface is one of the major challenges that must be overcome to improve the performance of kesterite-based TFSCs. In this paper, we demonstrate the relationship between device pa-rameters and performances for chemically deposited CdS buffer/CZTS-based heterojunction TFSCs as a function of buffer layer thickness, which could change the CdS/CZTS interface conditions such as conduction band or valence band offsets, to gain deeper insight and under-standing about Voc-deficit behavior from high recombination rate at CdS buffer/kesterite interface. Experimental results show that device pa-rameters and performances are strongly dependent on the CdS buffer thickness. We postulate two meaningful consequences; (i) Device pa-rameters were improved upto a CdS buffer thickness of 70 nm, while they deteriorated at thicker CdS buffer layer. The Voc-deficit in the solar cells improved up to a CdS buffer thickness of 92 nm, and then deteriorated at thicker CdS buffer layer. (ii) The minimum values of device parameters obtained at 70 nm CdS thickness in the CZTS TFSCs. Finally, the highest conversion efficiency of 8.77% (Voc: 494 mV, Jsc: 34.54 mA/cm2, FF: 51%) is obtained by applying to the Cu2ZnSn(S,Se)4 (CZTSSe) absorber layer using 70 nm thick CdS buffer.Keywords
Funding Information
- National Research Foundation of Korea (NRF-2015R1C1A1A02036616)
- Korea Institute of Energy Technology Evaluation and Planning (20164030201310)
This publication has 64 references indexed in Scilit:
- Non-toxic complexing agent Tri-sodium citrate’s effect on chemical bath deposited ZnS thin films and its growth mechanismJournal of Alloys and Compounds, 2012
- Preparation and characteristics of chemical bath deposited ZnS thin films: Effects of different complexing agentsJournal of Alloys and Compounds, 2012
- Studies on Cu2ZnSnS4 (CZTS) absorber layer using different stacking orders in precursor thin filmsSolar Energy Materials and Solar Cells, 2011
- A study on the improved growth rate and morphology of chemically deposited ZnS thin film buffer layer for thin film solar cells in acidic mediumSolar Energy, 2011
- Effect of different annealing conditions on the properties of chemically deposited ZnS thin films on ITO coated glass substratesSolar Energy Materials and Solar Cells, 2011
- Defect physics of the kesterite thin-film solar cell absorber Cu2ZnSnS4Applied Physics Letters, 2010
- Cu2ZnSnS4Cu2ZnSnS4 thin film solar cells prepared by non-vacuum processingSolar Energy Materials and Solar Cells, 2009
- Thin‐film solar cells: device measurements and analysisProgress in Photovoltaics: Research and Applications, 2004
- Effect of impurities in the CdS buffer layer on the performance of the Cu(In, Ga)Se2 thin film solar cellJournal of Applied Physics, 1999
- Developing an understanding of the processes controlling the chemical bath deposition of ZnS and CdSJournal of Materials Chemistry, 1998