Evaluation of Efficiency of Polymerization, Surface Roughness, Porosity and Adaptation of Flowable and Sculptable Bulk Fill Composite Resins
Open Access
Abstract
A new category of commercial bulk fill composite resins (CRs) enables the placement of 4-mm-thick layers as an alternative to the traditional time-consuming incremental technique. The purpose of the present study was to compare the efficiency of the polymerization, adaptation and porosity of two high-viscosity ‘sculptable’ bulk fill CRs (Filtek™ Bulk Fill (3M™ ESPE, St. Paul, MN, USA) and Tetric EvoCeram® Bulk Fill (Ivoclar Vivadent AG, Schwan, Liechtenstein)) and two low-viscosity ‘flowable’ bulk fill CRs (SureFil® SDR™ flow (Dentsply Sirona, Charlotte, NC, USA) and Tetric EvoFlow® Bulk Fill (Ivoclar Vivadent AG, Schaan, Liechtenstein)). Cylindrical samples of the bulk fill CRs (4 mm height × 10 mm diameter) were analyzed by Fourier-transform infrared spectroscopy (FTIR) and atomic force microscopy (AFM). Additionally, occlusal cavities were prepared in twelve extracted human molars and restored with the bulk fill CRs (n = 3 for each CR). The adaptation and porosity of the bulk fill CRs were evaluated by X-ray microcomputed tomography (µCT) with a 3D morphometric analysis, and the adaptation was also analyzed by scanning electron microscopy (SEM) on longitudinal vestibulo-oral sections of the restored teeth. The AFM analysis demonstrated that the surface roughness of the SureFil® SDR™ flow was higher than that of the Tetric EvoFlow® Bulk Fill and that the surface roughness of Filtek™ Bulk Fill was higher than that of Tetric EvoCeram® Bulk Fill. µCT and SEM confirmed that the flowable bulk fill CRs had excellent adaptation to the cavity walls. The 3D morphometric analysis showed the highest and lowest degrees of porosity in Filtek™ Bulk Fill and Tetric EvoFlow® Bulk Fill, respectively. In general, the flowable bulk fill CRs exhibited better adaptation, a higher efficiency of polymerization and lower porosity than the sculptable materials.Keywords
Funding Information
- Fulbright Association (PS00232562)
This publication has 31 references indexed in Scilit:
- Depth of cure of resin composites: Is the ISO 4049 method suitable for bulk fill materials?Dental Materials, 2012
- In vitro comparison of mechanical properties and degree of cure of bulk fill compositesClinical Oral Investigations, 2012
- 3D-marginal adaptation versus setting shrinkage in light-cured microhybrid resin compositesDental Materials, 2007
- Porosity in composite resinsBiomaterials, 1995
- Determination of the degree of cure of dental resins using Raman and FT-Raman spectroscopyDental Materials, 1993
- An investigation into the incidence of voids in indirect composite inlays formed using different packing techniquesJournal of Dentistry, 1991
- Margin analysis of posterior composites in vivoDental Materials, 1991
- The effect of placement technique upon the compressive strength and porosity of a composite resinJournal of Dentistry, 1989
- SEM study of surface characteristics and marginal adaptation of anterior resin restorations after 3?4 yearsEuropean Journal of Oral Sciences, 1985
- Tooth colored dental restorative materials: Porosities and surface topography in relation to bacterial adhesionActa Odontologica Scandinavica, 1982