PRODUCTION OF AA7075/B4C COMPOSITE MATERIALS BY SEMI-SOLID STIRRING METHOD
Open Access
- 30 December 2019
- journal article
- Published by INESEG Yayincilik in European Journal of Technic
Abstract
AA7075 aluminum alloy was reinforced with B 4 C particles to produce aluminum composite materials. In the production of AA7075/B 4 C composite materials, semi-solid mixing methods were applied for homogen reinforcement dispersion then low pressure solidification. For the determination of the mechanical properties of the obtained samples; three point bending, compression and hardness tests were performed. In addition, microstructure, reinforcement matrix interface and chemical structure of the composite material produced by SEM, EDS, XRD analysis were examined. As a result, it was observed that; using the semi-solid mixing method the reinforcing powders could be distributed homogeneously into the matrix, both chemical and mechanical bonding could be occurs between the matrix and the reinforcing material and this mixing technique could be easily used in the production of particle reinforced metal composites.Keywords
This publication has 4 references indexed in Scilit:
- Investigation of wear behaviours of Al matrix composites reinforced with different B4C rate produced by powder metallurgy methodAdvanced Powder Technology, 2017
- Al 2024 Esaslı B4C/SiC Parçacık Takviyeli Hibrit Kompozitlerin TIG Kaynağı ile BirleştirilmesiÇukurova Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi, 2016
- Evaluation of drilling Al/B4C composites with carbide drillsPamukkale University Journal of Engineering Sciences, 2016
- Effect of passivation and precipitation hardening on processing and mechanical properties of B4C–Al compositesCeramics International, 2011