Physico-thermal properties of kenaf fiber/high-density polyethylene/maleic anhydride compatibilized composites
- 31 May 2018
- journal article
- conference paper
- Published by SAGE Publications in High Performance Polymers
- Vol. 30 (8) , 900-910
Abstract
Kenaf fiber/high-density polyethylene/maleic anhydride (MA)-compatibilized composites were melt mixed in a twin-screw extruder and molded using injection molding machine. Physicothermal properties of the composites were studied at different percentages of compatibilizer contents using various techniques. The addition of 8% compatibilizer into 8.5 and 17.5 wt% fiber content improved the adhesion and tensile strength by 14.5% and 13.6%, respectively. Compatibilized samples exhibited higher peak load and fracture energy on impact testing compared to the samples without maleic anhydride compatibilizer. The effect of the addition of maleic anhydride compatibilizer on peak load and fracture energy was observed to be at its highest at 8%. Differential scanning calorimetric measurements revealed that the melting enthalpy and degree of crystallinity of composites increased with increasing compatibilizer content up to 8% and then decreased at 12% compatibilizer content. Dynamic mechanical analysis showed that the storage modulus of composites was increased, but the loss modulus and tangent delta were decreased after the addition of compatibilizer. This indicates that compatibilized composites produced have improved toughness and reduced stiffness.Keywords
Funding Information
- Institut Pengurusan dan Pemantauan Penyelidikan, Universiti Malaya (PS 347-2010A and PV 003-2011B)
This publication has 27 references indexed in Scilit:
- Improvement in the mechanical performance and interfacial behavior of kenaf fiber reinforced high density polyethylene composites by the addition of maleic anhydride grafted high density polyethyleneJournal of Polymer Research, 2014
- Rice husk ash – A valuable reinforcement for high density polyethyleneMaterials & Design (1980-2015), 2012
- Kenaf‐bast‐fiber‐filled biodegradable poly(butylene succinate) composites: Effects of fiber loading, fiber length, and maleated poly(butylene succinate) on the flexural and impact propertiesJournal of Applied Polymer Science, 2011
- Thermal properties of high density polyethylene composites with natural fibres: Coupling agent effectPolymer Degradation and Stability, 2008
- Effect of different compatibilizing agents on the mechanical properties of lignocellulosic material filled polyethylene bio-compositesComposite Structures, 2007
- Thermal properties of bio-flour-filled polyolefin composites with different compatibilizing agent type and contentThermochimica Acta, 2006
- Interfacial, dynamic mechanical, and thermal fiber reinforced behavior of MAPE treated sisal fiber reinforced HDPE compositesJournal of Applied Polymer Science, 2006
- Effectiveness of Maleated and Acrylic Acid-Functionalized Polyolefin Coupling Agents for HDPE-Wood-Flour CompositesJournal of Thermoplastic Composite Materials, 2003
- Effectiveness of functionalized polyolefins as compatibilizers for polyethylene/wood flour compositesPolymer Engineering & Science, 2003
- Renewable Agricultural Fibers as Reinforcing Fillers in Plastics: Mechanical Properties of Kenaf Fiber-Polypropylene CompositesIndustrial & Engineering Chemistry Research, 1995