Nonlinear Dynamics of Cutting Process considering Higher‐Order Deformation of Composite Cutting Tool
Open Access
- 1 January 2021
- journal article
- research article
- Published by Wiley in Shock and Vibration
- Vol. 2021 (1)
Abstract
In this paper, the nonlinear dynamic analysis of the cutting process of composite cutting tool is performed. The cutting tool is simplified to a nonplanar bending rotating shaft. The higher-order bending deformation, structural damping, and gyroscopic effect of cutting tool are considered. It is assumed that cutting tool is subjected to a regenerative two-dimensional cutting force containing the first and second harmonic components. Based on the Hamilton principle, the motion equation of nonlinear chatter of the cutting system is derived. The nonlinear ordinary differential equations in the generalized coordinates are obtained by Galerkin method. In order to analyze the nonlinear dynamic response of cutting process, the multiscale method is used to derive the analytical approximate solution of the forced response for the cutting system under periodic cutting forces. In the forced response analysis, four cases including primary resonance and superharmonic resonance, i.e., , , , and , are considered. The influences of ratio of length to diameter, structural damping, cutting force, and ply angle on primary resonance and superharmonic resonance are investigated. The results show that nonlinearity due to higher-order bending deformation significantly affects the dynamic behavior of the milling process and that the effective nonlinearity of the cutting system is of hard type. Multivalued resonance curves and jump phenomenon are presented. The influences of various factors, such as ratio of length to diameter, ply angle, structural damping, cutting force, and rotating speed, are thoroughly discussed.Keywords
Funding Information
- National Natural Science Foundation of China (11672166)
This publication has 32 references indexed in Scilit:
- Dynamic simulation of boring processInternational Journal of Machine Tools and Manufacture, 2009
- Microendmill Dynamics Including the Actual Fluted Geometry and Setup Errors—Part I: Model Development and Numerical SolutionJournal of Manufacturing Science and Engineering, 2008
- Prediction of chatter in high speed milling including gyroscopic effectsInternational Journal of Machine Tools and Manufacture, 2006
- Design and manufacture of a carbon fiber epoxy rotating boring barComposite Structures, 2003
- Suppression of chatter vibration of boring tools using impact dampersInternational Journal of Machine Tools and Manufacture, 2000
- Development of a composite boring barComposite Structures, 1997
- Towards improved design of boring bars part 1: Dynamic cutting force model with continuous system analysis for the boring bar performanceInternational Journal of Machine Tools and Manufacture, 1988
- Effect of a Variable Stiffness-Type Dynamic Damper on Machine Tools with Long Overhung RamBulletin of JSME, 1976
- A Theory of Nonlinear Regenerative ChatterJournal of Engineering for Industry, 1974
- Theory of Self-Excited Machine-Tool Chatter: Contribution to Machine-Tool Chatter Research—1Journal of Engineering for Industry, 1965