Effect of TiO2 Content on the Arc-Erosion Resistance of Ag/SnO2 Electrical Contact Materials Prepared via Mechanical Alloying-Assisted Powder Metallurgy
Authors:
Top Cited Papers
Open Access
- 16 February 2026
- journal article
- research article
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 55 (4) , 3850-3867
Abstract
In this study, the arc-erosion performances of AgSnO 2 -based electrical contact materials containing different amounts of titanium dioxide (TiO 2 ) were investigated using the mechanical alloying-assisted powder metallurgy method. For this purpose, composite powder synthesis was carried out through grinding experiments using a planetary ball mill, and the produced composite powders were subjected to molding and vacuum sintering processes. Subsequently, electrical wear tests were carried out under inductive loads to investigate the arc-erosion performance of composites. Scanning electron microscopy (SEM), energy dispersive x-ray spectroscopy (EDS), and laser diffractometry techniques were used to characterize powders, green compacts, composites and arc-affected surfaces. The results showed that the smallest composite powder size (1.186 µm) was obtained from samples containing 7% by weight of TiO 2 . Furthermore, it was determined that the green compacts containing 1% TiO 2 had the lowest porosity ratio (1.21%). In addition, the hardness values were observed to gradually increase from 82 HV to 112 HV with increasing TiO 2 content. It was also observed that the use of 5% TiO 2 improved the interfacial wettability between the matrix and reinforcement, thereby increasing the viscosity of the abraded material and reducing particle spatter. One of the key findings of the study is that, under test conditions of 220 V, 50 Hz, and 20 A, the addition of 5% TiO 2 reduced total mass losses by 46.78%.Keywords
Funding Information
- Karadeniz Teknik Üniversitesi (KTUBAP)
- Karadeniz Teknik Üniversitesi (Project No: 1073)
- Karadeniz Technical University
This publication has 91 references indexed in Scilit:
- Effect of Y2O3 on electric performance of Ag–SnO2–Y2O3 composite electrical contact materialsJournal of Materials Science: Materials in Electronics, 2025
- Preparation and Arc Erosion Behavior of Novel Ag-TiN Electrical Contact MaterialsMetallurgical and Materials Transactions B, 2024
- Improvement of Arc Erosion Resistance of Ag–SnO 2 Contact Materials by Reducing Molten Pool SizeAdvanced Engineering Materials, 2024
- Synthesis and characterization of undoped and copper-doped zinc oxide nanowires for optoelectronic and solar cells applicationsApplied Physics A, 2021
- Hybridization effect of BN and Al2O3 nanoparticles on the physical, wear, and electrical properties of aluminum AA1060 nanocompositesApplied Physics A, 2021
- Characterization/mechanical behavior of AgCuOSnO2 composites: Experimental and finite element studyPolymer Composites, 2021
- Study of structural, magnetic and optical properties of oxygen plasma-treated manganese-doped iron oxide photocatalyst for wastewater treatmentApplied Physics A, 2021
- Effect of electric load characteristics on the arc-erosion behavior of Ag-4 wt.%TiB2-4 wt.%Ni electrical contact materialApplied Physics A, 2021
- Novel ZA27/B4C/Graphite Hybrid Nanocomposite-Bearing Materials with Enhanced Wear and Corrosion ResistanceMetallurgical and Materials Transactions A, 2020
- Properties Enhancement of an Eco-Friendly Electrical Contact Material by Silver Nanoparticles AdditionMetallurgical and Materials Transactions A, 2012