Novel TIM Evaluation Method With in Situ Electrical Monitoring
- 26 January 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 13 (2) , 171-176
Abstract
Thermal interface materials (TIMs) transfer heat between two surfaces in electronic assemblies. Specifically, a TIM 2 is a TIM used to transfer heat from a component’s lid to a heat sink. During use, TIM 2s experience thermal aging and mechanical stress (caused by board/component/heat sink expansion mismatches and warpage during heating/cooling). Understanding the response of TIMs to these stresses is critical for understanding TIM and product reliability. However, the responses of TIMs are complex and difficult to predict or model. TIMs are often polymeric materials heavily loaded with thermally conductive fillers and have time, temperature, and rate-dependent properties. Therefore, experimental studies are needed to address TIM reliability. However, monitoring TIM stability or performance while in situ is difficult. Electrical capacitance has been used to monitor the stability of dielectric TIM in situ, allowing for monitoring TIM stability and, indirectly, the TIM thermal performance. But electrically conductive TIMs cannot be used with capacitance measurements, so a new technique is needed. Monitoring a conductive TIM’s electrical resistance could give insight into a TIM’s stability, as thermal and electrical resistance are both affected by a TIM’s contact with surfaces, thickness, and area. This study examines four electrically conductive graphite pad TIMs on a test board, representing a large printed circuit board with a large shared heat sink, in an accelerated thermal cycle from 0 to 100°C. The electrical resistance of the TIMs was monitored in situ, and after testing post mortem failure analysis of the TIMs was done. The efficacy of electrical resistance monitoring for evaluating TIM stability was examined, and correlations with failure analysis results were made. Electrical resistance monitoring provided insight into the TIMs’ stability, failure time, and extent of failure.Keywords
Funding Information
- Universal Instruments Corporation’s Advanced Research in Electronic Assemblies (AREA) Consortium
This publication has 25 references indexed in Scilit:
- Characterization Methods for Solid Thermal Interface MaterialsIEEE Transactions on Components, Packaging and Manufacturing Technology, 2017
- Reliability of thermal interface materials: A reviewApplied Thermal Engineering, 2013
- Characterization method for thermal interface materials imitating an in-situ environmentMicroelectronics Journal, 2012
- Thermal interface materials for automotive electronic control unit: Trends, technology and R&D challengesMicroelectronics Reliability, 2011
- Compact Thermal Network Model of the Thermal Interface Material Measurement Apparatus With Multi-Dimensional Heat FlowIEEE Transactions on Components, Packaging and Manufacturing Technology, 2011
- Considerations in the Use of the Laser Flash Method for Thermal Measurements of Thermal Interface MaterialsIEEE Transactions on Components, Packaging and Manufacturing Technology, 2011
- Hierarchical Nested Surface Channels for Reduced Particle Stacking and Low-Resistance Thermal Interfaces2007
- Performance and testing of thermal interface materialsMicroelectronics Journal, 2003
- Electrical and thermal transport properties of magnetically aligned single wall carbon nanotube filmsApplied Physics Letters, 2000
- Thermal Diffusivity of Dispersed MaterialsJournal of Heat Transfer, 1978