Size Distribution of Diesel Soot in the Lubricating Oil
Authors:
- 1 October 1991
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Soot is the largest component of contaminants found in the diesel engine lubricating oil. The soot enters lubricating oil mainly through thermophoretic deposition on the cylinder wall. Although the mechanism is still not fully understood, it is generally accepted that soot particles promote engine wear, reducing engine component service life, fuel efficiency and performance. This problem will be further exacerbated when more and more diesel engines use EGR to reduce NOx emissions and when lubricating oil consumption is drastically reduced to control particulate emissions. In this study, lubricating oil samples were taken from 7 different operating diesel engines. The size distribution and concentration of the diesel soot particles in the lubricants were investigated by methods of photosedimentation and quantitative spectrophotometry. The size distributions were compared to those of soot particles in the exhaust. It was found that the mass weighted median diameter of soot particles in the lubricating oil varies from 0.12 to 0.27 μm, and the geometrical standard deviation from 2.4 to 4.0, largely dependent on the type of the engines. The soot size distribution in the oil is in general similar to that in the exhaust. For a single cylinder diesel engine, soot particles were found entering the lubricating oil at a rate of approximately 4% of the total dry exhaust particulate mass emission rate, which in turn is about 0.1% of the fuel mass consumed.Keywords
This publication has 21 references indexed in Scilit:
- Particulate Emissions from Diesel Engines:Influence of In-Cylinder SurfaceSAE International Journal of Advances and Current Practices in Mobility, 1990
- Review of Lubricant Contamination and Diesel Engine WearSAE International Journal of Advances and Current Practices in Mobility, 1988
- Correlating Lube Oil Filtration Efficiencies with Engine WearSAE International Journal of Advances and Current Practices in Mobility, 1988
- In-Cylinder Measurements of Soot Production in a Direct-Injection Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1988
- The Study of the Effect of Exhaust Gas Recirculation on Engine Wear in a Heavy-Duty Diesel Engine Using Analytical FerrographySAE International Journal of Advances and Current Practices in Mobility, 1986
- By-Pass Lube Oil FiltrationSAE International Journal of Advances and Current Practices in Mobility, 1986
- Oil Thickening in the Mack T-7 Engine Test—Fuel Effects and the Influence of Lubricant Additives on Soot AggregationSAE International Journal of Advances and Current Practices in Mobility, 1985
- Effect of Oil Formulations in Minimizing Viscosity Increase and Sludge Due to Diesel Engine SootSAE International Journal of Advances and Current Practices in Mobility, 1984
- Process through which Soot Intermixes into Lubricating Oil of a Diesel Engine with Exhaust Gas RecirculationSAE International Journal of Advances and Current Practices in Mobility, 1982
- Soots from Used Diesel Engine Oils - Their Effects on Wear as Measured in 4-Ball Wear TestsSAE International Journal of Advances and Current Practices in Mobility, 1981