An Approach to Assessing S960QL Steel Welded Joints Using EBW and GMAW
Open Access
Abstract
In recent years, ultra-high-strength structural (UHSS) steel in quenched and tempered (Q+T) conditions, for example, S960QL has been found in wider application areas such as structures, cranes, and trucks due to its extraordinary material properties and acceptable weldability. The motivation of the study is to investigate the unique capabilities of electron beam welding (EBW) compared to conventional gas metal arc welding (GMAW) for a deep, narrow weld with a small heat-affected zone (HAZ) and minimum thermal distortion of the welded joint without significantly affecting the mechanical properties. In this study, S960QL base material (BM) specimens with a thickness of 15 mm were butt-welded without filler material at a welding speed of 10 mm/s using the high-vacuum (2 × 10−4 mbar) EBW process. Microstructural characteristics were analyzed using an optical microscope (OM), a scanning electron microscope (SEM), fractography, and an electron backscatter diffraction (EBSD) analysis. The macro hardness, tensile strength, and instrumented Charpy-V impact test were performed to evaluate the mechanical properties. Further, the results of these tests of the EBW joints were compared with the GMAW joints of the same steel grade and thickness. Higher hardness is observed in the fusion zone (FZ) and the HAZ compared to the BM but under the limit of qualifying the hardness value (450 HV10) of Q+T steels according to the ISO 15614-11 specifications. The tensile strength of the EBW-welded joint (1044 MPa) reached the level of the BM as the specimens fractured in the BM. The FZ microstructure consists of fine dendritic martensite and the HAZ predominantly consists of martensite. Instrumented impact testing was performed on Charpy-V specimens at −40 °C, which showed the brittle behavior of both the FZ and HAZ but to a significantly lower extent compared to GMAW. The measured average impact toughness of the BM is 162 J and the average impact toughness value of the HAZ and FZ are 45 ± 11 J and 44 ± 20 J, respectively.Keywords
Funding Information
- Hungarian Higher Education Excellence Programme (N/A)
This publication has 39 references indexed in Scilit:
- Effect of heat input on the mechanical properties of welded joints in high-strength steelsWelding International, 2015
- Correlating welding reaction stresses and weld process conditions for high-strength steel S960QLWelding in the World, 2014
- Fatigue Crack Propagation Limit Curves for High Strength Steels and their Application for Engineering Critical Assessment CalculationsAdvanced Materials Research, 2014
- Effect of diffusible hydrogen level on heat-affected zone hydrogen-induced cracking of high-strength steelsWelding in the World, 2013
- Enhancement of mechanical properties and failure mechanism of electron beam welded 300M ultrahigh strength steel jointsMaterials & Design (1980-2015), 2013
- Electron Beam Welding Of Atmcp Steel With 700 Mpa Yield StrengthWelding in the World, 2012
- Quenching microstructure and properties of 300M ultra-high strength steel electron beam welded jointsMaterials & Design (1980-2015), 2012
- Influence of the Soft Zone on The Strength of Welded Modern Hsla SteelsWelding in the World, 2012
- Microstructure and residual stress distribution of similar and dissimilar electron beam welds – Maraging steel to medium alloy medium carbon steelMaterials & Design (1980-2015), 2010
- TECHNOLOGICAL PROCEDURES OF ELECTRON BEAM WELDING AND REPAIRMaterials and Manufacturing Processes, 1992