Influence of additional inlet flow on the prerotation and performance of centrifugal impellers
- 1 March 2003
- journal article
- research article
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 41 (2) , 207-216
Abstract
In this paper we present the results of our experimental analysis regarding the influence of additional flow when added at the radial impeller entrance eye. This analysis was done on both operating and prerotation flow characteristics. The experimental system tested was arranged to operate using air. The additional flow adding system (AFAS) was placed at the entrance eye of the impeller through the guide system, which consists of the spiral volute at the entrance, ring guide pipe (where the guide vanes are placed), and a ring - like hollow at the end of the AFAS. The ring - like hollow was placed near the shroud at the entrance edge of the impeller blades. The guide vanes in the AFAS were placed in the axial direction, so that the added flow had no swirl component. The operating regime was tested, whereby the AFAS was filled by the flow under atmospheric pressure (non-forced loading). A good influence was evident on the operating characteristic. The stable operating range was enlarged and the operating noise decreased. The achieved impeller head and the overall efficiency increased.Keywords
This publication has 5 references indexed in Scilit:
- Torsional Vibrations at Guide-Vane Shaft of Pump–Turbine ModelShock and Vibration, 1997
- Unsteady Flow Within Centrifugal Compressor Channels Under Rotating Stall and SurgeJournal of Turbomachinery, 1992
- Secondary Flow and Loss Distribution in a Radial Compressor With Untwisted Backswept VanesJournal of Turbomachinery, 1991
- Strömungsmaschinen1986
- Axial- und Radialkompressoren1961