Impact of Vertical Vibration on Group Piles During Earthquake Loading: Experimental Findings
Authors:
Open Access
- 8 October 2024
- journal article
- Published by Ital Publication in Civil Engineering Journal
- Vol. 10, 174-208
Abstract
This study presents novel research on the impact of vertical vibration on the dynamic response of pile groups embedded in stratified soil under seismic loading conditions. An experimental setup was employed wherein the piled machine foundation was subjected to vertical vibrations at three operating frequencies (10, 20, and 30 Hz) and subsequently exposed to four levels of seismic acceleration (0.1 g, 0.34 g, 0.77 g, and 0.82 g). Piles with a length-to-diameter ratio of 25 were embedded in a stratified soil profile, with an upper loose layer (30% relative density) and a lower dense layer (80% relative density) acting as end-bearing. Measurements and analyses of horizontal and vertical accelerations, and amplification factors were conducted using the Fast Fourier Transform (FFT), spectral acceleration (Sa), and variation of acceleration with depth. The results demonstrated a significant reduction in horizontal acceleration, with a peak ground acceleration (PGA) reduction of up to 64% in average, particularly at higher frequencies such as 30 Hz. The mitigation efficiency at 30Hz improved with increasing PGA, showing reductions of 42, 68, 75, and 63% for seismic accelerations of 0.1 g, 0.34 g, 0.77 g, and 0.82 g, respectively. The analysis further revealed harmonic resonance and higher mode effects at lower frequencies, with nonlinear soil behavior affecting the resonance and amplification patterns. Additionally, the results demonstrate that the far-field accelerations exceeded the near-field accelerations within the pile group, particularly in the surface layer. The results indicated that the initial vibration amplitudes exceeded the safe operating limits outlined in ACI 351.3R-18 under seismic loading, particularly at higher seismic acceleration levels and lower frequencies. Additional modified charts were presented to account for these conditions. The results presented promising evidence for using vertical vibrations as an earthquake-mitigation strategy. However, avoiding operating at frequencies less than 10 Hz is recommended because of the potential resonance and interaction with horizontal accelerations during earthquakes. Doi: 10.28991/CEJ-SP2024-010-010 Full Text: PDFKeywords
This publication has 70 references indexed in Scilit:
- Elastic surface wave attenuation in layered soil by metastructuresLow-carbon Materials and Green Construction, 2024
- A Comprehensive Review of the Nonlinear Response of Soil Deposits and its Implications in Ground Response AnalysisIndian Geotechnical Journal, 2023
- Dynamic impedance parameters of floating piles subjected to coupled harmonic vibrationArabian Journal of Geosciences, 2023
- Prediction and Modeling for Local Site Amplification Effect of Ground Motion: Exploring Optimized Machine Learning ApproachesPure and Applied Geophysics, 2022
- Effect of Pile Arrangements on the Dynamic Coupled Response of Pile GroupsGeotechnical and Geological Engineering, 2020
- Numerical analysis of the boundary effect in model tests for single pile under lateral loadBulletin of Engineering Geology and the Environment, 2017
- Dynamic Response and Dynamic Failure Mode of a Weak Intercalated Rock Slope Using a Shaking TableRock Mechanics and Rock Engineering, 2016
- Determination of ductility factor considering different hysteretic models1999
- Modeling of nonstationary ground motion and analysis of inelastic structural responseStructural Safety, 1990
- Dynamic behaviour of building‐foundation systemsEarthquake Engineering & Structural Dynamics, 1974